Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Hope I did this correctly. Have a look

14 Feb 2014   #11
richc46

Microsoft Community Contributor Award Recipient

Windows 10, Home Clean Install
 
 

Sorry that you are experiencing memory problems, but its cheap and easy to fix and your BSOD problems will, most likely be over.


My System SpecsSystem Spec
.
14 Feb 2014   #12
Layback Bear

Windows 10 Pro. 64/ version 1709 Windows 7 Pro/64
 
 

How long should I test 1 stick at a time?
My System SpecsSystem Spec
14 Feb 2014   #13
richc46

Microsoft Community Contributor Award Recipient

Windows 10, Home Clean Install
 
 

You should run each stick at least several hours. Many test all of the ram overnight for 8 hours.
My System SpecsSystem Spec
.

15 Feb 2014   #14
Layback Bear

Windows 10 Pro. 64/ version 1709 Windows 7 Pro/64
 
 

Still testing ram.
Testing the last ram module and I still have to check each slot. Their is a down side of having a lot of ram. That would be the time it takes for testing.
My System SpecsSystem Spec
16 Feb 2014   #15
Layback Bear

Windows 10 Pro. 64/ version 1709 Windows 7 Pro/64
 
 

I have tested all modules one at a time. The one bad one that I didn't have installed at the time of the BSOD is still bad as it was 2 week ago. That took up 16 hours.
It passed with two ram modules installed and I'm testing now with 4 modules installed.
I'm posting all this just to let you know that I'm going to do one hellofa ram and motherboard slot test. I want to find the ugly nasty little bugger that is causing my problem.
I intend to be writing a book with this system and I don't want to have 4 pages wrote and a BSOD remove everything before I get it saved. My three brain cell would get very angry.
My System SpecsSystem Spec
16 Feb 2014   #16
Britton30
Microsoft MVP

Windows 7 Ultimate X64 SP1
 
 

Jack what size RAM DIMMs do you have?
Your specs say 24GB but I can't figure out how to have that on a Quad channel board without having one channel not fully populated.
My System SpecsSystem Spec
16 Feb 2014   #17
Layback Bear

Windows 10 Pro. 64/ version 1709 Windows 7 Pro/64
 
 

I started out with 32 gigs. I had to remove 2 modules about a week or so ago because one was bad. I'm now at 24 gigs.
I do believe as long as the ram is installed 2 sticks at a time it will stay in quad channel.
I'm running a memory test on that computer at this time.
I will check and post when done with the testing.
I have got about 25 hours of testing done and about 5 more hours to go.
I have 8 sticks of ram @ 4 gigs.; 6 are installed now. Three hours into the test and all is good so far.
My System SpecsSystem Spec
16 Feb 2014   #18
Britton30
Microsoft MVP

Windows 7 Ultimate X64 SP1
 
 

OK, I'm curious about 4 channel, does CPUz or MaXXmem2 report you in 4 channel mode?

Oh, for testing single RAM stick they should also go for at least 8 passes too. Memtest86+ uses different values in each pass and some errors won't show at 3-4 passes at times.
My System SpecsSystem Spec
16 Feb 2014   #19
Layback Bear

Windows 10 Pro. 64/ version 1709 Windows 7 Pro/64
 
 

Done memory testing I think. Six modules installed and all pass.
CPU-Z shows quad channel mode.
My BSOD happened when I was doing nothing but online on this Forum or watching Hulu.
I cleared everything Event Logs, Mini Dumps ect. and will wait for another BSOD.
My System SpecsSystem Spec
16 Feb 2014   #20
richc46

Microsoft Community Contributor Award Recipient

Windows 10, Home Clean Install
 
 

Use the computer, in your normal fashion. After about 6 BSODs, submit to us. Each BSOD gives a small clue. More than one is needed.
My System SpecsSystem Spec
Reply

 Hope I did this correctly. Have a look




Thread Tools




Similar help and support threads
Thread Forum
Is there any hope ????
bought a 4gb HDD months ago. Finally got around to plugging it in. Disaster. It is split into 2 drives 1x2gb 1x1.6 gb The 2TB partition initialized fine. The 1.6Tb unallocated space is faded out. Cannot touch it. The simple solution is send it back. Ebay order istoo old. No...
Hardware & Devices
Hope everyone has been doing well.
With my new job along with the extensive travel I've been subject to lately I've lost contact with the board the last few months. I would like to wish all the best to everyone and say I hope all is well with you. Once things slow down I will be back in full swing, but until then take care and...
Chillout Room
I hope somebody can help me
I have just gone from Vista to Windows 7 on a new computer, I have also installed Microsoft Works Task Launcher so that I can read my transferred info from Vista. However all my Spreadsheet Documents come up in Abode Reader and I keep getting a message, saying "Abode Reader could not open the...
General Discussion
Hi im new here hope you can help
Hi Everyone my name is Steve, I have a problem with my start menu appearing after i hit any key to return to my desktop after my monitor has gone off after the screen saver has been on then monitor goes off after. apart from periodical reboots for windows updates I never shut down down pc. im...
General Discussion
I hope anyone can tell me this.....?
I am looking where i can change this image file, or where i can change the color. I have seen it in other colors but i never found out how.:mad: I hope anyone knows cause i am getting annoyed by that little blue *****.
Customization


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 04:57.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App