Code:
*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************
KERNEL_DATA_INPAGE_ERROR (7a)
The requested page of kernel data could not be read in. Typically caused by
a bad block in the paging file or disk controller error. Also see
KERNEL_STACK_INPAGE_ERROR.
If the error status is 0xC000000E, 0xC000009C, 0xC000009D or 0xC0000185,
it means the disk subsystem has experienced a failure.
If the error status is 0xC000009A, then it means the request failed because
a filesystem failed to make forward progress.
Arguments:
Arg1: fffff6fc4000c798, lock type that was held (value 1,2,3, or PTE address)
Arg2: ffffffffc000000e, error status (normally i/o status code)
Arg3: 00000001424f2860, current process (virtual address for lock type 3, or PTE)
Arg4: fffff880018f3ca8, virtual address that could not be in-paged (or PTE contents if arg1 is a PTE address)
Debugging Details:
------------------
ERROR_CODE: (NTSTATUS) 0xc000000e - A device which does not exist was specified.
DISK_HARDWARE_ERROR: There was error with disk hardware
Run SeaTools to check the integrity of your HDD. SeaTools for DOS and Windows - How to Use
Run chkdsk. Disk Check
Uninstall DaemonTools, a known cause of BSODs.
1. Uninstall Daemon Tools.
2. Download the SPTD standalone installer and follow these steps:
3. Double click the executable to open it
4. Click the button shown below
If the button it is grayed out, as shown in the image, there is no more SPTD installation on your system, and you can just close the window.