New
#11
ok i ran dm log collector again. i attached the file
ok i ran dm log collector again. i attached the file
If you would, please run check disk (Disk Check) and the long and short test with Seatools (SeaTools for DOS and Windows - How to Use) Run the DOS version if you can, if not you can use the installed version.
Also try this and make sure you have the latest version od DirectX, which you probably do. How to install the latest version of DirectX
I have the latest direct x. I ran a disk check before and it took so long and it didn't do anything. I followed the instructions for the dos thing but the instructions are kind of hard to follow. I downloaded the program and put it on a CD. I booted the cd by entering bios and the agreement came up. I accepted it and didn't have an option of long or short test. It said I.couldn't detect the hard drive or something and the only option was to exit.
Ok I just restored to factory settings again. I couldn't boot in safe mode every time the only options were start up repair and start windows normally. Should I wait for another bsod or just do it now? Last time I restored to factory settings it.took around 2 to 3 hours to get a bsod
Well something is wrong. To finish factory reset I have to reboot. Upon doing so I got the bsod.... It then looped back to start up and gave the options for safe mode and when I chose that it says it won't finish factory reset in safe mode...
Try running startup Repair. You may have to run it 3 times with attempted reboots between each time. Startup Repair