BIOS BootUP Warning Message (Pic) After New graphics card installation

Page 1 of 2 12 LastLast

  1. Posts : 7
    Windows 7 Home Premium 64-bit
       #1

    BIOS BootUP Warning Message (Pic) After New graphics card installation


    First off I recently Installed a new graphics card, the EVGA GTX 750 ti (SC edition) and I loved it but shortly after I broke one blade on my CPU fan because it was hitting its plastic case and making an incredibly loud noise.

    Then after a few days I noticed a decrease in performance with slower load speeds and applications crashing if I had too many open etc. (on the brightside gaming graphics and FPS went way up =D) until this morning I received this message on bootup.



    Now there are 2 issues that come to mind - not having enough power for the new graphics card or the CPU over heating from one fan blade breaking. I would rather not find out my PC is slowly dying from the recent changes because I cannot afford a new one. Are there maybe some fan setting or overheat warnings i can configure in BIOS?

    Here is my Power Supply, CPU fan and full specs:







    Motherboard: GA-78LMT-S2
    CPU: AMD FX 4100 Zambezi (Max TDP 95 W)
    Graphics: Nvidia Geforce Gtx 750 ti SC
    Ram : DDR3 2x4GB stick (dunno what brand)
    Power Supply: [In Image]
    Optical Drive: TSSTcorp CDDVDW SH-224BB SATA CdRom Device
    Hard Drive: 1TB TOSHIBA DT01ACA100 SATA Disk Device (dont know rpm)
    Fans: no idea cooler master i believe
    64-bit Win7
      My Computer


  2. Posts : 3,187
    Main - Windows 7 Pro SP1 64-Bit; 2nd - Windows Server 2008 R2
       #2

    What temperatures are you seeing for the CPU?
      My Computer


  3. Posts : 7
    Windows 7 Home Premium 64-bit
    Thread Starter
       #3

    Ok i downloaded core temp and will let it run under some stress to see my maximum temp
      My Computer


  4. Posts : 7
    Windows 7 Home Premium 64-bit
    Thread Starter
       #4

    Not much more than ~35 degrees C
      My Computer


  5. Posts : 3,187
    Main - Windows 7 Pro SP1 64-Bit; 2nd - Windows Server 2008 R2
       #5

    In no particular order:

    That temp is alright.
    Your video card is not a huge power draw, as far as those go.
    Your PSU is a bargain brand and the amperage on the 12V rails is mighty low.

    The BIOS warning you are getting is a standard response to an incomplete boot on a system with something running perhaps a little out of spec. Probably anyone who has ever overclocked (even mildly) has seen that at some point. If you were not getting that repeatedly, especially at stock speeds, I would not be too concerned. It might be just a one-off occurrence.

    In any event, I would replace that fan. Running out of balance like that it's not going to last long anyway.

    As for the computer slowdown, I would recommend making sure the hardware is sound and running properly for a few days before tackling that. If everything looks good we can get into that next. :)
      My Computer


  6. Posts : 7
    Windows 7 Home Premium 64-bit
    Thread Starter
       #6

    Sorry about the late reply went out of town for a few days hope you still see this, on another forum someone replied

    "First I would replace the CPU fan. Second that card takes 25 watts on a 12v+ rail.
    Your psu has dual rails at 14watts each now here is the kicker Two 12v rails at 14 watts does not equal 28 watts on the 12v rail.
    If you have two rails at 14 amps each you are pushing the same as 20 watts on a single rail.

    So to make your computer last longer and not burn anything up replace the cpu fan and get a single rail PSU with at least 30 amps on the 12v rail. And that is still a bit low to me because you have to figure in the hard drives, fans, ram, dvd drives when in use, and CPU.

    The CORSAIR CX series CX430 430W is cheap and has a single rail at 32 amps.
    and the CORSAIR CX series CX500 500W cost a bit more but carries 38 AMPs on the 12v rail."

    Which agrees with your opinion but since im rather short on money right now is it vital to upgrade my PSU? I will be replacing the fan though. And also to further report I haven't gotten anymore overclock warnings but my PC did blue-screen once and a desktop.ini file appeared on my desktop out of nowhere. Hope none of this is too serious because I really could not afford a new PC right now.
      My Computer


  7. Posts : 7
    Windows 7 Home Premium 64-bit
    Thread Starter
       #7

    Brado11 said:
    "First I would replace the CPU fan. Second that card takes 25 watts on a 12v+ rail.
    Your psu has dual rails at 14watts each now here is the kicker Two 12v rails at 14 watts does not equal 28 watts on the 12v rail.
    If you have two rails at 14 amps each you are pushing the same as 20 watts on a single rail.

    So to make your computer last longer and not burn anything up replace the cpu fan and get a single rail PSU with at least 30 amps on the 12v rail. And that is still a bit low to me because you have to figure in the hard drives, fans, ram, dvd drives when in use, and CPU.

    The CORSAIR CX series CX430 430W is cheap and has a single rail at 32 amps.
    and the CORSAIR CX series CX500 500W cost a bit more but carries 38 AMPs on the 12v rail."
    Also could you explain some of these numbers to me as I don't know that much about electricity PSU's etc. Thank you so much in advance @profdlp
      My Computer


  8. Posts : 3,187
    Main - Windows 7 Pro SP1 64-Bit; 2nd - Windows Server 2008 R2
       #8

    Sorry, had a 400 mile trip today and am just checking my email.

    In a nutshell, PSUs vary in how much current they can supply, with the higher rated ones costing more due to having better components. Some PSUs take a shortcut and put a pair of cheaper components in there instead of one really super-duper one. In your case, it means you have a puny 14A main feed (rail) and to try and make up for it they threw in a second one.

    This is an imperfect analogy, but think of it like a guy trying to win the Indy 500 who couldn't afford a real Indy car which could go 180mph. Suppose he tried to make up for it by buying two midrange sports cars which could each hit 90mph. 2 x 90 = 180, right? Trouble is he can only drive one of them at a time. The second car might be handy for his friend to run to the store in and buy him some beer to console himself after he loses the race, but it's not going to help him with his main task.

    Video cards are typically the highest users of power in a computer and they need a quality PSU to deliver it. You can postpone it if you must, but your best bet is to start saving and keep your eye on sales so you can hopefully get a good price.

    As for the desktop.ini file, that's always "there" but is usually hidden. Check and see if somehow you have managed to get the "Hide Protected Operating System Files (Recommended)" box unchecked. (See bottom of attached picture.) If it is, put the check back and that should take care of it.
      My Computer


  9. Posts : 19,383
    Windows 10 Pro x64 ; Xubuntu x64
       #9

    Just checking....are any components overclocked? From the BIOS screen that appears to be the case. Reset all overclocks to stock settings. The system may stay stable until you can afford fixes/replacements.
      My Computer


  10. Posts : 25,847
    Windows 10 Pro. 64/ version 1709 Windows 7 Pro/64
       #10

    I'm also a believer that it is a power supply problem.

    Search Results


    1. Requirements
      • Minimum of a 550 Watt power supply. (Minimum recommended power supply with +12 Volt current rating of 38 Amps.)
      • An available 6-pin PCI-E power connector and an available 8 pin PCI-E power connector.
    2. EVGA GeForce GTX 570 HD Classified Video Card Review ...

      evga-geforce-gtx-570-hd-classified-video-card-revi...
      My Computer


 
Page 1 of 2 12 LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 14:51.
Find Us