Daily BSOD...

TC, please fill in your system specs, it would be very helpful to us.

Please follow this tutorial and download the tool. The tool will give you detailed information about your system specs, please fill in your system specs more completely.
How to fill in your system specs:

Here we go, a BSOD just now.

TC, please fill in your system specs, it would be very helpful to us.

Yep Axe mate I did ask that back in post#33 but anyway it obviously slipped TC's mind as I did post a fair bit back then

PS Found this for that stop code don't know if it is of any help as there seems to be a lot of answers

Blue screen showing Stop: 0x000000F4 - Microsoft Community

But it will be good to get your dumps

Just went right back again TC and mate can you please humour me up and run this

Using HW Info

PART A:

You can test the volts onthe PSU with HW Info HWiNFO,HWiNFO32/64 - Download <download the right bit version and close the right hand window select Sensorsand scroll down to the power section where you will see what the volts aredoing see my pic. In my pic the section (Nuvoton)with VBATT is a dead give away you are in the section for the rail voltages.There are other section titles and one that pops up often is ITE

Now the voltage on thedifferent rails have to be within 5% =+/- of what is required or the machinewill not work properly if at all.

See this for the railvoltage info

http://www.tomshardware.com/reviews/power-supply-specifications-atx-reference,3061.html (Section 2.)

The original right handwindow shows the machine running and is handy for that but for looking at thecomponents in some detail close it and use the main left hand side panel

FOR OTHER COMPONENTS

PART B:

Open each small squarewith + in it on the section the components are in and then click on theindividual component/s (it willhighlight in blue) - in the right hand side will appear all sorts of detailsincluding brands speeds and other essential info that particular device. Seepic for example.

I am asking because if the PSU is not delivering the correct volts on the devices three main rails and the Power Good signal being kept at it's nominal voltage then none of the rest of the machine is going to work properly. The Power Good signal can be read with a digital multimeter at pin 8 (grey cable) on the 24 pin board socket and see my pic for what section in the Sensor readout you are looking for.

That link of Microsoft is not much helpful to me, but I need the logs to get more info on what the problem could be.

TC, please run the BSOD tool again and upload the zip file.

The above, right, ICIT?

That link of Microsoft is not much helpful to me

Well me neither really axe mate but thought it worth a shot checking out.

TC rails all ok mate I like to keep them within that 5% +/-. When you need to check other stuff out to PART B: will give you very detailed readings on whatever we are checking out.

That is particularly so when the BSOD dumps start throwing faults for dedicated components.