Puzzling BSOD issues with ntoskrnl.exe


  1. Posts : 5
    Windows 7 Home Premium 64 bit
       #1

    Puzzling BSOD issues with ntoskrnl.exe


    Hi, first time posting here and I could really use the help.
    I have been experiencing weird BSOD issues these past 2 days and thus far have been unable to put my hand down on what is causing it. The issue is intermittent too so it is really frustrating.
    I have been running memtest overnight and it gave me 0 errors with 7 passes.
    I been running prime95 all morning and there has been no issue yet.
    So I doubt it is a RAM or CPU issue.

    I have uploaded all my crashdumps into dropbox
    https://www.dropbox.com/s/7i5a2gq1k6...Dumps.rar?dl=0
    Here for easier viewing

    I could really use the hand
    Last edited by Waxcommon; 15 Nov 2015 at 05:07. Reason: Uploaded BSOD file
      My Computer


  2. Posts : 7,050
    Windows 10 Pro
       #2
      My Computer


  3. Posts : 5
    Windows 7 Home Premium 64 bit
    Thread Starter
       #3

    I was only able to get the file for my latest BSOD. I hope it helps, I am really loss here. I edited my first post to include what you instructed.
      My Computer


  4. Posts : 7,050
    Windows 10 Pro
       #4

    Please read this post carefully.

    If you are using a program like Ccleaner please stop using it while troubleshooting.
    This because programs like Ccleaner remove dump files that are needed to troubleshoot.
    Or configure Ccleaner to not remove dump files:


       Warning
    Programs that claim to update your drivers install either the wrong or corrupted drivers.
    If you have installed any driver with DriverMax, please remove them as it may cause trouble.


    From where do you need 2 VPN's?

    What test(s) have you performed with Prime95?

    If below results are good, you might need to run driver verifier a couple of times if you have used DriverMax.
    I'll give instructions for driver verifier when the results are good.




    Diagnostics Test

     System File Check


    Please try following:
    • Open an admin command prompt
    • Copy/paste "sfc/scannow" (without quotes) and press enter
    • When it finished reboot your system
    • Open again an admin command prompt
    • Enter sfc/scannow again

    If sfc/scannow does NOT say "Windows Resource Protection did not find any integrity violation", please upload the cbs.log file located at {windows partition}\Windows\Logs\CBS\, if the file is too large try a 3rd party uploader like dropbox, onedrive, google drive, mediafire etc.
    System File Check(SFC a.k.a. Windows Resource Protection) needs to have your system rebooted in order for sfc to try to fix the problems that it finds.




    Diagnostic Test

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 7 Forums

       Note


    MemTest86+ needs to be run for at least 8 passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.
      My Computer


  5. Posts : 5
    Windows 7 Home Premium 64 bit
    Thread Starter
       #5

    Alright. I will stop using CCleaner.
    I have 2 VPNs one to access my school network while the other is my personal general use VPN.
    I ran the blend test for Prime 95 for roughly 6 hours.
    I have removed drivermax as instructed.
    I ran memtest86 for 8 passes last night with no errors.
    I have tried sfc/scannow and it came back clean already
      My Computer


  6. Posts : 7,050
    Windows 10 Pro
       #6

    Any driver installed with drivermax?

    Please keep in mind that there are different tests for the CPU, each test tests something else.
      My Computer


  7. Posts : 5
    Windows 7 Home Premium 64 bit
    Thread Starter
       #7

    I don't think so as far as I recall.
    What test do you suggest for my CPU? I have run the Intel Processor diagnostic test as well and that was turned up clean as well.
      My Computer


  8. Posts : 7,050
    Windows 10 Pro
       #8

    None, yet. I'd rather first know what the results of MemTest86+ are.
      My Computer


  9. Posts : 5
    Windows 7 Home Premium 64 bit
    Thread Starter
       #9

    I ran memtest for 7 passes the night before. I got 0 errors. I read this forum a little and I saw that 8 passes was the conclusive result. I ran memtest again last night for 8 passes. 0 errors again. On the bright side, I have been using the computer for 7+ hours since I finished last night's memtest and I have yet to run into a single BSOD yet. Crossing my fingers so far.
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 14:30.
Find Us