Occasional BSOD apprently when using

Page 2 of 2 FirstFirst 12

  1. Posts : 9
    Windows 7 Ultimate 64
    Thread Starter
       #11

    I've cut and pasted the code you've listed above into a cmd prompt run as administrator. These are Attachment 400295all the files that it created. I did see, however, that it said the system cannon find the path specified a=during the process.
      My Computer


  2. Posts : 7,050
    Windows 10 Pro
       #12

    Fixed the command.





    Diagnostic Test

     DRIVER VERIFIER


       Warning
    Please make a backup of your important files and get your rescue media or create one.
    Please create a restore point.

    Please follow this tutorial to run driver verifier.

    Driver verifier stresses your drivers and will crash your pc if any driver fails due to a violation.

    Driver verifier should be performed for a max of 48 hours, or when you have a bluescreen, whatever comes first.

    If driver verifier has found a violation and you can't get back into windows normally, try to boot into safe mode and reset in safe mode driver verifier, or in the troubleshooting options open command prompt and type verifier /reset.

       Note
    Your system will act very sluggishly while driver verifier is enabled, this is normal as your drivers will be being subjected to heavy testing in order to make them crash.
      My Computer


  3. Posts : 9
    Windows 7 Ultimate 64
    Thread Starter
       #13

    i enabled verifier and had a crash. Is there new code that I should use to generate the files?
      My Computer


  4. Posts : 7,050
    Windows 10 Pro
       #14

    This time just upload the new minidump as a zip :)
      My Computer


  5. Posts : 9
    Windows 7 Ultimate 64
    Thread Starter
       #15

    Thanks so much for taking all this time for this. Here ya go.
      My Computer


  6. Posts : 7,050
    Windows 10 Pro
       #16




    Diagnostic Test

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 7 Forums

       Note


    MemTest86+ needs to be run for at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.


    Make a photo of the result and post it.

    Addition:
    If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
    If errors show up and you see them a lot later, no problem, the errors don't affect the test.
      My Computer


  7. Posts : 9
    Windows 7 Ultimate 64
    Thread Starter
       #17

    Well, although I know very little about the memtest that i just did, I DO know that what I'm seeing isnt good. I assume I should replace my RAM. I have 8 - 8 GB sticks. From what I understand, Corsair has a lifetime warranty.
      My Computer


 
Page 2 of 2 FirstFirst 12

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 00:24.
Find Us