BSOD even after factory reset 0x00000116

Page 1 of 2 12 LastLast

  1. Matulhs
    Posts : 10
    Windows 7 Home premium 64bit
       New #1

    BSOD even after factory reset 0x00000116


    Hi.

    I need help on my dell window 7 laptop. I was streaming yesterday and suddenly my laptop reboot and shows a blue screen. It says:

    "Technical information:

    ***STOP: 0x00000116 (0xFFFFFA8007CB6010, 0xFFFFF880042DB8F0, 0X0000000000000000, 0x0000000000000002)

    ***. atikmpag.sys - Address FFFFG880042DB8F0 base at FFFFF880042D40000, DateStamp 4edd79fe"

    I tried googling the solution to my problem, it says to uninstall my video configuration from my device manager and try to install it back. Yes, i uninstall as instructed. Then, i tried to find the same video driver(?) From dell. But it really took long time to download (sloww internet connection) . Therefore I cancelled the download and i factory reset my laptop. And now, it keeps on rebooting and BSOD appear. I tried to access by using safe mode, but cannot as i need to complete my installation since i factory reset it.

    Tried to repair computer and the startup repair. None of them work. Restore? Also didnt work. So do the safe mode. I really hope there's someone who can help me with my problem. Fyi, i did not have any dvd / cd for the restore thingy. Wish you guys could help me.
      My Computer
    Quote Quote

  3. axe0
    Posts : 7,050
    Windows 10 Pro
       New #2

    How old is the laptop?
    What model is your laptop?

    What do you get when trying to use a restore point, reset the system and boot to safe mode?
      My Computer
    Quote Quote

  4. Matulhs
    Posts : 10
    Windows 7 Home premium 64bit
    Thread Starter
       New #3

    I bought this laptop since 2012. It is Dell Inspiron N4050.

    When i try to boot after safe mode, the screen appear "setup is preparing your computer for first use." Then few seconds later, pop up screen "windows cannot complete installation in safe mode. To continue installing windows, restart the computer." Then, when i restart, the BSOD screen shows again.

    I already factory reset my laptop, but the BSOD is still there. And i cannot even use safe mode.

    When i tried to use the system recovery option ( system restore) , it says that "no restore points have been created on your computer's system drive. To create a restore point open system protection. "

    Do i have a chance that my laptop can recover? Or should i just dump this one and buy a new one?
      My Computer
    Quote Quote

  6. axe0
    Posts : 7,050
    Windows 10 Pro
       New #4

    How far did the factory reset come?
      My Computer
    Quote Quote

  7. Matulhs
    Posts : 10
    Windows 7 Home premium 64bit
    Thread Starter
       New #5

    Tried to start my laptop, but the BSOD keep on coming. And it stuck there. And it keeps on restarting.
      My Computer
    Quote Quote

  8. axe0
    Posts : 7,050
    Windows 10 Pro
       New #6

    Please answer my question, how far did the factory reset come?

    While I ask questions to get a clear point at what happened, I would suggest to run a diagnostics test.
    Knowing what happened helps in identifying the issue.




    Diagnostic Test

     RAM TEST


    Run MemTest86+ to analyse your RAM. MemTest86+ - Test RAM - Windows 7 Forums

       Note


    MemTest86+ needs to be run for at least 8 complete passes for conclusive results. Set it running before you go to bed and leave it overnight. We're looking for zero errors here. Even a single error will indicate RAM failure.


    Make a photo of the result and post it.

    Addition:
    If errors show up you can stop the test, remove all sticks but 1 and test this single stick in each slot for 8 passes or until errors show, switch sticks and repeat.
    If errors show up and you see them a lot later, no problem, the errors don't affect the test.
      My Computer
    Quote Quote

  10. Matulhs
    Posts : 10
    Windows 7 Home premium 64bit
    Thread Starter
       New #7

    I already factory reset my laptop. It was a success. However, I'm stuck in the installation part. I cannot successfully install the setup since I cannot boot my laptop with both normally and safe mode. Cuz if i start normally, i got stuck at the BSOD screen again.

    I'm testing the RAM now. Currently 42%. Will update you once finish.
      My Computer
    Quote Quote

  11. Matulhs
    Posts : 10
    Windows 7 Home premium 64bit
    Thread Starter
       New #8

    Matulhs said:
    I already factory reset my laptop. It was a success. However, I'm stuck in the installation part. I cannot successfully install the setup since I cannot boot my laptop with both normally and safe mode. Cuz if i start normally, i got stuck at the BSOD screen again.

    I'm testing the RAM now. Currently 42%. Will update you once finish.

    Am I answering your question? Sorry I'm trying my best to answer your question. :)
      My Computer
    Quote Quote

  12. axe0
    Posts : 7,050
    Windows 10 Pro
       New #9

    Make sure to read my questions and suggestions carefully.

    A factory reset is not only deleting everything, but also reinstalling everything. As you described it, it did not finish.

    42%? Make sure to complete 8+ passes.
      My Computer
    Quote Quote

  13. Matulhs
    Posts : 10
    Windows 7 Home premium 64bit
    Thread Starter
       New #10

    Yes, it did not finish reinstalling.

    Anyway, i've let the Memtest86+ run for 53hours now with 42 passes. And ZERO errors. What should i do next? Should i wait for it to run some more?
      My Computer
    Quote Quote

 
Page 1 of 2 12 LastLast

  Related Discussions
BSOD after factory reset
in BSOD Help and Support

Recently I had a virus on my computer. Microsoft security essentials picked it up and claimed to remove it. My computer was still slow, but neither avast or mse picked anything up in scans. Eventually I decided to restore to factory settings. I've done this in the past without any problems but this...
BSOD Still crashes after a factory reset. Attempt to reset the display driver and recover from timeout failed. I thought a clean factory reset will fix the issue. But it is still has the BSOD. I have uploaded the zip file that contains the dump as instructed.
RANDOM BSOD even after Factory reset
in BSOD Help and Support

You read it right. Even after the factory reset I continue to get random BSOD. This started happening last year. After going off the edge one day with this thing :cry:, I reset it. It froze the day of the reset when I was rebuilding my desktop again. The improvement after the reset is that it...
my friend still getting bsod even after factory reset and using the hp software to update drivers and bios. BSOD still happen just take a lot longer to happen, we reset because the viruses were to painful to remove, and much corrupted registry.
BSOD even after factory reset
in BSOD Help and Support

I think i have some virus that has affected the factory restore area. I can work the laptop in safe mode. but at the moment internet explorer is the only program i can get to work. BSOD come as soon as started up in normal mode. Windows 7 home premium, acer aspire 5820T I have attached...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 15:02.
Find Us