BSODs, IRQL_NOT_LESS_OR_EQUAL, Unstable System

Page 4 of 9 FirstFirst ... 23456 ... LastLast

  1. Posts : 1,309
    Windows 7 Ultimate 32 bit
       #31

    what is your ram configuration 2x2 gigs or 4x1 gig? are they all the same make model spec? are you sure they are in correct slots for dual channel mode? are voltages correct?
      My Computer


  2. Posts : 41
    Windows 7
    Thread Starter
       #32

    unfortunately, I don't.
      My Computer


  3. Posts : 1,309
    Windows 7 Ultimate 32 bit
       #33

    in the bios the SATA controller is it set to AHCI or IDE if it's set to AHCI change it to IDE
      My Computer


  4. Posts : 41
    Windows 7
    Thread Starter
       #34

    It's set to IDE.
      My Computer


  5. Posts : 1,309
    Windows 7 Ultimate 32 bit
       #35

    have you tried replacing the SATA cables they are fragile and don't like being bent in weird positions I had a run of brand new cables shipped with new motherboards from Biostar that were bad I was pulling my hair out trying to chase down BSOD's and weird errors on a handful of brand new systems I built it turned out to be the SATA cables
      My Computer


  6. Posts : 41
    Windows 7
    Thread Starter
       #36

    I will go and buy some new cables tomorrow, and give them a shot.
      My Computer


  7. Posts : 1,309
    Windows 7 Ultimate 32 bit
       #37

    I would with the amount of errors your getting it sounds like data corruption
      My Computer


  8. Posts : 41
    Windows 7
    Thread Starter
       #38

    Bought a new serial ata cable, and replaced the previous one connecting the harddrive to the mobo. Did a clean install. I have since then installed solidworks, microsoft office, adobe flash, and Avira with no problems what-so-ever! (knock on wood). I am going to keep using the computer and see if things hold steady. Who would have guessed a $3 dollar cable would make a $1000 computer worthless?
      My Computer


  9. Posts : 1,309
    Windows 7 Ultimate 32 bit
       #39

    I have had it happen more times than you could imagine SATA and PATA cables both
      My Computer


  10. Posts : 41
    Windows 7
    Thread Starter
       #40

    Well, i didn't knock on wood hard enough. Now I can't open any applications.
    WerFault.exe - Application Error
    The instruction at 0x0000028a referenced memory at 0x0000028a. The memory could not be written.

    iexplore.exe - Application Error
    The instruction at 0x71767d2c referenced memory at 0x69672010. The memory could not be read.
      My Computer


 
Page 4 of 9 FirstFirst ... 23456 ... LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 04:36.
Find Us