Windows 7 Forums

Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: Random BSOD - Fresh install, fresh system

20 Jan 2010   #31
computersplus

Windows 7 Ultimate 32 bit
 
 

put in one stick at a time and run test till yo find the faulty stick


My System SpecsSystem Spec
.
20 Jan 2010   #32
ManOwar2

Windows 7 x64
 
 

Quote   Quote: Originally Posted by computersplus View Post
put in one stick at a time and run test till yo find the faulty stick
Do not matter to me wich one is faulty.

If this is a garantee that my ram is faulty, this memtest 3.4,

I will buy new one and get refund for that one.

Please confirm to me that this test result mean my ram is faulty...and not another component :/
My System SpecsSystem Spec
20 Jan 2010   #33
Pauly

Win7 Ultimate X64
 
 

Could also be MB (but most likely ram) check each stick seperately to see if only one gives you a prob and find a good stick and try it in all MB slots to check they are all ok
My System SpecsSystem Spec
.

20 Jan 2010   #34
computersplus

Windows 7 Ultimate 32 bit
 
 

like Pauly said could be a board issue but most likely it's ram the only way to know for sure is to check one stick at a time until you find one that puts up errors
My System SpecsSystem Spec
20 Jan 2010   #35
ManOwar2

Windows 7 x64
 
 

I do not think I have the time or the patience to test every single one. I will buy new ram, return that one and I will try... I have until the 29 of january for them to receive the unit back for a refund so I wont take achance. If this is the mobo fault after, I will need to deal with ASUS wich is going to be easier than dealing with g.skill who didnt answered my after 5 days of requests...

Do you guys think it can be incompatiblity problem ?

I must mention thant when we built the system in the first place...My bro did a mistake and and plugged a PCI express pin in the 4-^pin mobo for the power. The system would not open of course...it showed power in the mobo but nothing would open.

Do you think it could have damaged something related to the ram ? We we're thinking it would probably not damaged anything since nothing opened up and then everything worked fines...

I'm not sure what do to do, except changing the ram...
My System SpecsSystem Spec
20 Jan 2010   #36
computersplus

Windows 7 Ultimate 32 bit
 
 

that depends on how he plugged it in what pins went where from that plug so yes it's possible but since it is working it's probably ok just sounds like ram go to Asus website and look at approved ram for that board some boards are picky about ram
My System SpecsSystem Spec
20 Jan 2010   #37
p1tcho0

Windows 7 64 BIT
 
 

Hi, Im the guy that have builded the pc of manowar2

PS:Im not good in english sorry


I have two ask about this problem

The first ask

Could we think the problem can be only compatibilty board

We know, DDR2 DDR3 its a standart, but some model is not perfect with some board spent several years

In the website of GSKILL

The mem is Not Qualified Vendor list

QVL
ASUS Rampage Extreme
ASUS P5E3 Premium
ASUS P5E3 Deluxe
ASUS P5Q3 Deluxe
ASUS P5Q3
ASUS P5P43TD
ASUS P5P43TD Pro

But Why P5E3 PRO was not listed...

Change brand can be way ? Like kingston Hyper X

I know, normally is not very important because we can get any RAm for any board today and all its okay.

But i would like to get opinion about that


Second ask

All hardware is new...

But an error have maded when i built the computer

I made fault when i plug P4 wire plug of mobo,

I dont have put the good wire i have plugged 6-pin wire.. ( for video card)

The computer does not start.

Protection electricity was here in the board but can be damaged the board

What is opinion about that

===================

===================

The last ask

We know Memtest got good reputability

Can we say its same accurate with hardware tester and software tester ?

What is difference ?


Alex
My System SpecsSystem Spec
20 Jan 2010   #38
computersplus

Windows 7 Ultimate 32 bit
 
 

in order to minimize potential problems it's always best to use ram qualified for your board and make sure all Bios settings are correct for voltage timings and speed.

Also just because something is new does not mean it's good I get defective parts shipped to me more than you could imagine.

there is always potential for damage when you plug in the wrong power connectors be very careful about that.
My System SpecsSystem Spec
20 Jan 2010   #39
p1tcho0

Windows 7 64 BIT
 
 

Quote   Quote: Originally Posted by computersplus View Post
that depends on how he plugged it in what pins went where from that plug so yes it's possible but since it is working it's probably ok just sounds like ram go to Asus website and look at approved ram for that board some boards are picky about ram

If we check the pin ! ! ! 6 pin 4 pin ! !
! ! ! ! !

The error was 2 pin at left was not in hole of p4 board lik that

! X X
! X X

Used !
My System SpecsSystem Spec
20 Jan 2010   #40
computersplus

Windows 7 Ultimate 32 bit
 
 

if you are in doubt RMA board plain and simple
My System SpecsSystem Spec
Reply

 Random BSOD - Fresh install, fresh system




Thread Tools




Similar help and support threads
Thread Forum
Random BSOD fresh win7 install system service exception
Hello everyone, this is my first time on this forum. I recently built my own computer but have been getting random BSOD. They happen randomly while doing nothing in particular, every few hours. I couldn't figure out the problem so I sent my PC to best buy geek squad. After over 2 weeks (they said...
BSOD Help and Support
Random BSOD(different error). Fresh install!
Hi, Operating System: Win7 Home Basic (when it was bought it had a Windows 7 home basic installed) - Tried all from Win7 Starter to Win7 Ultimate => x32-x64. - Installation date: Few hours ago. - PC(aspire 7551G) age: 2/5 years 1st BSOD => few minutes after install
BSOD Help and Support
Random BSOD after fresh install of Windows 7 on a SSD.
Just reinstalled Windows on a new Samsung PM 830 SSD. Can't tell if its the SSD or the other things that I have installed. Sometimes it gives the BSOD screen, sometimes Explorer just goes missing and Task Manager would be unavailable. These days the BSODs come more often and with little...
BSOD Help and Support
Random BSOD's even after fresh install
Hi there, I have build my own system in June 2011 and since the start I am experiencing random BSOD's. I usually get a lot playing World of Warcraft. But also just browsing, watching a video or even when the PC is idle. I did a fresh install of W7 about 2 weeks ago, unfortunately this didn't...
BSOD Help and Support
Random BSOD following fresh install and new motherboard
I recently replaced my motherboard and RAM, and installed Windows 7 64bit and all was well to start with, until i started getting random BSOD. I got today the DRIVER_IRQL_NOT_LESS_OR_EQUAL and IRQL_NOT_LESS_OR_EQUAL for which i updated the official drivers for the NIC and Audio drivers this...
BSOD Help and Support
Random BSOD after a few Hours of a fresh install
After I install windows 7 64 bit Home P and all the lates driver. My system will work fine for about a few hours. Then my will start not to respond and crash. Setup I7 860 Gigabyte P55A-UD3 Version 1.0 1TBx2 Hatachi on Raid 1 8 GB of Ram
BSOD Help and Support


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd

All times are GMT -5. The time now is 02:34.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App