BSOD's Again...

Hi,did you open the PC for anything recently,like to change anything ,

To change anything? no...
But I did open it up today to see if all the wires were still aright (which they were) and to clean out dust.

Ok just check that everything is seated properly,like the ram and the graphics card etc,with the power off of course,meaning nothing loose.

Got me flumuxed > Would have suggested a roll back but you proberly have tried that . If its hardware related hard to fathom from this end . Good luck with your problem and have you tried a frsh install ?

@ jfar, Yes everything was fine inside

@ Whoosh, I did try many fresh installs,
(Did one today aswell)

It's very annoying when I can only see the result at the first boot...
But I'll see tomorrow if the new build did any good :)

Vista isn't a solution either, cause vista gives BSOD's & w7 gives error's @ the same first boot o the day