Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: DISKPART : At PC Startup / Tutorial

22 Oct 2010   #1
Bare Foot Kid
Microsoft MVP

W 7 64-bit Ultimate
 
 
DISKPART : At PC Startup / Tutorial

This is just a simple little guide that I wish I would have had yesterday; I hope it'll be useful.

DISKPART : At PC Startup
My System SpecsSystem Spec
23 Oct 2010   #2
Bare Foot Kid
Microsoft MVP

W 7 64-bit Ultimate
 
 

Quote   Quote: Originally Posted by Bare Foot Kid View Post
This is just a simple little guide that I wish I would have had yesterday; I hope it'll be useful.

DISKPART : At PC Startup


Just wanted to bump this up in-case some have not seen it.
My System SpecsSystem Spec
Reply

Thread Tools


Similar help and support threads
Thread Forum
Diskpart Showing no connected drives while in 7 Startup repair
PC is booting to startup animation but not moving past. Started up windows repair and recovered to earlier point. No dice. Loaded up CMD in the start-up repair and ran a bootrec.exe /fixboot. Error. Bootrec.exe /scanos, None found. Which is weird because it boots into the start-up animation so that...
Hardware & Devices
DISKPART : At PC Startup
Open Windows DISKPART at System Startup This is an outline of the methods to boot (start) the PC to open DISKPART so you can manipulate the Solid State Drive (SSD) or Hard Disk Drive (HDD) partitions before you start an installation or for any other reason. Let's get started! Windows 7 Full...
Tutorials
Diskpart
I am trying to do a diskpart/clean all via command prompt. Should the command prompt opened via repair menu at startup be at c:\windows\system32 or x:\sources or doesn't matter? Here is the tutorial that I am doing this according to: ...
General Discussion
DiskPart help
Ok i couldn't mark my D partition as active because there wasn't a "Mark as Active" in diskmgmt.msc. so i tried to do it in command Prompt like it is described here.https://www.sevenforums.com/tutorials/71432-partition-mark-active.html?ltr=P But the problem is that there is 3 partitions listed...
Installation & Setup
Using Diskpart
Hello everyone. What I would like is to do is a "secure erase" (write zeroes) to a partition of a HDD before a clean install of Windows 7. If I were to boot to a https://www.sevenforums.com/tutorials/682-command-prompt-startup.html?ltr=C would the series of commands in the snip below...
General Discussion


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 09:33.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App