New
#71
Well, I don't quite know what happened there. I did a sig last night, and posted it (or so I thought).
Logged on this morning - gone!
Anyway, sorry about that! Fixed now. See my previous post.
Wenda.
Hmmm, yes. My fault about the sig not posting last night, I was half-asleep at the time.
Now, regarding resizing/transparency, I checked the dimensions, which are 639mm x 147mm (for some reason, the size on the posted sig is shown in pixels) so I played around a bit with them, and did a test
post or two. Still transparency not working for me. File is saved as a *.png, as are all my sigs once I've
finished them (the original *.psd files are also saved, separately).
Another query is that my file sizes seem to be very large compared to some others. Not sure why this
would be, any ideas? I'm obviously doing something wrong, but I can't seem to spot it...
Wenda.
EDIT: OK, I read back into the last part of this thread, and I've now worked out where I was going wrong with the sizing, I was using mm, not pixels. The files are now an acceptable size.
Thanks for jogging my memory, A Guy.
However, even at 300x150 pixels, and saved as a *.png file, I'm still not getting the transparency. The sig below is the same one as previously, but re-sized from 640x150mm. The white rectangular back-
ground isn't in the original but keeps appearing here.
As I said, I know I'm doing something wrong but can't seem to pick quite where...
Last edited by Wenda; 02 Jun 2013 at 03:58.
Not a GFX guy, but the forum measurements are in pixels. 650x150. Not sure what equates to mm?
A Guy