USB to IDE win 7 missing driver-please help!!???  


  1. Posts : 2
    windows 7 ultimate 32 bit
       #1

    USB to IDE win 7 missing driver SOLVED


    I have purchased two 2.5" IDE hard drive enclosures (thought first one was broken). Whenever i plug in the USB cable, windows 7 tries to install the driver, but does not install the correct driver. I can see in device manager that a mass storage device is plugged in, but I can't access the device (i'm assuming its the wrong driver).

    I know the IDE drive works, because if i put it back into my old laptop it boots up just fine (i have win 7 installed on it). Also, I tried installing the drivers on the disk it came with, and checking the manufacturers website without any luck. The enclosure is a Sabrent sbt-eku25.

    Does anyone have the driver for USB to IDE on windows 7??? Or any other solution, if this is not it.
    Last edited by fastssl; 08 Feb 2011 at 14:22. Reason: adding "solved" to title
      My Computer


  2. Posts : 5,056
    Windows 7 x64 pro/ Windows 7 x86 Pro/ XP SP3 x86
       #2

    Try the solution on this page.

    USB to IDE drivers - Vista Forums
      My Computer


  3. Posts : 2
    windows 7 ultimate 32 bit
    Thread Starter
       #3

    Bill2 said:
    Try the solution on this page.

    USB to IDE drivers - Vista Forums
    Thanks for the response. I tried that but it did not work.

    But i did solve the problem by doing the following:

    the enclosure came with a "Y" type usb cable where in the end of the cable that goes into the computer there is a power+data cable and a power only cable end. I plugged the power+data into my computer and the power only into the wall socket (i have one of those adapters that lets you charge usb on a wall socket - its for my cell phone). After doing this, I could hear the drive spinning faster. I think it did not work because my laptop does not supply enough power through the usb ports. If i had a desktop this would probably work fine. So in fact, windows 7 does have the drivers built in, I just wasnt getting enough power from my usb hubs.

    Now I wish I could just turn up the power on my usb hubs (its probably turned down to save power; but I never unplug my laptop anyways, so it wouldnt matter to me).
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 09:11.
Find Us