initial 0 byte partition


  1. Posts : 79
    windows 7
       #1

    initial 0 byte partition


    When I clean installed W7 it would create 3 partitions
    0 byte = unallocated
    100MB - reserved
    and 80GB (the rest) = install

    Somehow, I eventually got rid of that 0 byte partition during one of my reinstalls.
    I thought I knew how I did it, but apparently not.

    I am trying to install W8 on a spare drive that I probably tried unsuccessfully to image my W7 system to when it still had the 0 byte partition.

    It is doing the same thing and I can't get rid of it.

    Any suggestions????????
      My Computer


  2. Posts : 4,751
    Windows 7 Home Premium 32-Bit - Build 7600 SP1
       #2

    ruggb said:
    When I clean installed W7 it would create 3 partitions
    0 byte = unallocated
    100MB - reserved
    and 80GB (the rest) = install

    Somehow, I eventually got rid of that 0 byte partition during one of my reinstalls.
    I thought I knew how I did it, but apparently not.

    I am trying to install W8 on a spare drive that I probably tried unsuccessfully to image my W7 system to when it still had the 0 byte partition.

    It is doing the same thing and I can't get rid of it.

    Any suggestions????????
    Use your Snipping Tool to post a picture of your Disk Management so we can see what it looks like.
      My Computer


  3. Posts : 79
    windows 7
    Thread Starter
       #3

    I managed to get rid of it again. My memory had a flashback..........

    Here is what I had to do.
    I connected the drive to my laptop via an ESata cable.
    I used disk manager to delete the partitions - 100MB and my system partition. The 0 byte was visible but I couldn't do anything with it because it was 0bytes.
    Once the others were unallocated they were all integrated.

    I created a partition with everything that was unallocated and formatted it.
    I connected it back to desktop and clean installed W7. The 0byte partition was gone.

    Apparently, since it shows up as an unallocated partition during the install, the above procedure was able to integrate it back so that the install didn't break it out again. Just strange that disk manager could do it and a clean install cannot.

    When I did it with the install the 0 byte showed until I deleted the 100MB - it was then "integrated". I deleted the system and had one unallocated area. As soon as I recreated the "system" partition, windows created the 100MB and system and the unallocated 0 byte was back.

    thx
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 04:11.
Find Us