single drive to raid 0 ?

Page 2 of 2 FirstFirst 12

  1. zigzag3143
    Posts : 28,845
    Win 8 Release candidate 8400
       New #11

    Ren

    Your welcome. btw welcome to sevenforums. have fun

    ken
      My Computer
    Quote Quote

  3. chev65
    Posts : 8,870
    Windows 7 Ult, Windows 8.1 Pro,
       New #12

    Hmm I never have any problems with my software RAID0.

    Good descriptions of all the RAID set ups here. RAID - Wikipedia, the free encyclopedia
      My Computer
    Quote Quote

  4. torrentg
    Posts : 5,747
    7600.20510 x86
       New #13

    My 2 main HDD are Sata but I also run 2 IDE HDD in software Raid-1 mirroring.
    It's my drive E:\ and I use it to put all my drivers, software installs and tools. I have been using it for many months, no problems.

    Today when I went into disk management to help someone else, it showed both of the physical HDD in the Raid as failed. But it was still functioning as normal when using it in Windows.

    So I told disk management to rebuild the array and it took like 5-10 minutes to "synchronize", as it was saying. Then it completed and Raid was all well again.

    And that's what happened. lol
      My Computer
    Quote Quote

 
Page 2 of 2 FirstFirst 12

  Related Discussions
I have a computer that was using RAID 1 with 2 HDD. I first removed one of the drives and attached my new SSD. Rebooted and let the RAID rebuild. Next I shut down and entered the RAID setup CTRL + I and removed the SSD drive from the RAID set by selecting (Non-RAID) in the controller. I then...
Hi Everyone, I have been having a challenge with changing from RAID 0 to a single drive, whilst retaining the data from the RAID array. To date I have performed the following: 1). Partitioned the single drive so that it closely matches the partitions on the RAID array. 2). Used XXClone...
Hi all, I am going to be retiring two RAID 1 HDD's and replacing them with a single SSD and I'm a bit fuzzy on the steps involved. I have all my data saved externally so I'll be doing a clean install of Windows 7 Pro x64. I have set it to non-RAID in the RAID menu but I'm not sure when I should...
I have windows 7 pro and running a raid 0 system. I am using Macrium 5 to backup the disk image. In the event of a HD failure will I be able to replace the raid drives with a single drive and restore the disk image or will I have to stay with a raid 0. I understand the drive or drives will have to...
I am running 7 pro 64bit on a ASUS p8p67 deluxe mobo and I copied all data from my 1tb storage D: drive to a backup external and proceded to install raid 5 with 3 single 1tb drives and the raid is up an running. However using Intel Rapid Storage Technology to setup the raid inside windows I had to...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 15:37.
Find Us