Should the "boot" be in the primary partition or on drive C.

Page 1 of 2 12 LastLast

  1. Posts : 9,746
    Windows 7 Home Premium 64 bit sp1
       #1

    Should the "boot" be in the primary partition or on drive C.


    Should the "boot" file be in the the Primary Partition or on drive C. I only have one drive & it is a Kingmax 240 gb SSD. In my case the "boot" is on C.
    At present I have to boot my computer twice to get it to start windows. The first time it loads the BIOS & then asks for booting media or reboot, which is what I have been doing lately. The second boot starts Windows normally.
    I have checked the boot order in the BIOS & at first start it will not detect the Kingmax drive, but on the second on it does recognise it.
    I did detect at one point briefly that "boot manager" was missing, but I have not seen that again.
    This has started since I did a firmware update on the SSD 2 days ago, so I suspect something has changed after that although the update went without any problems.
      My Computer


  2. Posts : 71,977
    64-bit Windows 11 Pro for Workstations
       #2

    Hello Bligh,

    You might run a startup repair to see if it may be able to help with the boot issue. If needed, you may need to run it up to 3 times with a restart between each.

    As a precaution, I would recommend to back up anything that you do not want to lose to another location just in case this may be an early sign of hard drive failure.

    Hope this helps for now, :)
    Shawn
      My Computer

  3.    #3

    Please post back a screenshot of Disk Management - Post a Screen Capture Image - Windows 7 Help Forums

    Make sure the System Reserved partition (preferred if you have it) or C is Partition Marked Active before running Startup Repair - Run up to 3 Separate Times until Win7 starts on its own and holds the System Active Boot flags on C.

    Last edited by gregrocker; 23 Sep 2013 at 11:37.
      My Computer


  4. Posts : 4,466
    Windows 10 Education 64 bit
       #4

    On my desktop PC the hidden System Reserved is marked as Active and the Windows Partition is marked as Boot. The System reserved is the first partition on the drive. It sounds to me like the firmware update is causing the BIOS to have a hard time iding the drive. I think I would reset the BIOS back to fail safe defaults. I would Also check the drive cables just to make sure they are connected properly.
      My Computer

  5.    #5

    He doesn't mention having System reserved but if he does then it should be marked System Active. This means it holds the (System) boot files while the Active flag points to this as the partition booting Win7.

    "Boot" only means the currently booted partition in Disk Mgmt. In Partition Wizard "Boot" and "System" are reversed to mean the oppostive, so there can be confusion.

    If the problem is that it won't boot without the disk, then make sure SysReserved (if you have it) or C is marked Active, then run three Startup Repairs to correctly repair or rewrite the boot files while checking all other boot parameters at the same time.
      My Computer


  6. Posts : 4,466
    Windows 10 Education 64 bit
       #6

    gregrocker said:
    He doesn't mention having System reserved but if he does then it should be marked System Active. This means it holds the (System) boot files while the Active flag points to this as the partition booting Win7.

    "Boot" only means the currently booted partition in Disk Mgmt. In Partition Wizard "Boot" and "System" are reversed to mean the oppostive, so there can be confusion.

    If the problem is that it won't boot without the disk, then make sure SysReserved (if you have it) or C is marked Active, then run three Startup Repairs to correctly repair or rewrite the boot files while checking all other boot parameters at the same time.
    That's kind of what I was getting at, I mentioned it so the OP could compare it to what he has. A screen shot of disk management would likely help sort it out.
      My Computer

  7.    #7

    Righto, thanks for noticing that he didn't rule out having SysReserved partition.

    Hopefullly we shall see.
      My Computer


  8. Posts : 9,582
    Windows 8.1 Pro RTM x64
       #8

    It is quite possible that the firmware update has caused the active flag on the drive to be reset.
      My Computer


  9. Posts : 4,466
    Windows 10 Education 64 bit
       #9

    The thing is though, on the reboot/second boot, Windows boots up normally. If it was something like a missing active partition setting, I would expect it to never boot up. That's why I think its a BIOS detection issue.
      My Computer


  10. Posts : 9,746
    Windows 7 Home Premium 64 bit sp1
    Thread Starter
       #10

    Many thanks to everyone who replied. Yes my drive does have a System Reserved partition as well as the normal C partition.
    I ended up having to get professional help as the BIOS was apparently corrupted or damaged & had to be reloaded & updated, as this is really beyond my abilities.
    Apparently the firmware update on the SSD was the likely culprit, so I certainly wont do that again without getting it done properly.
    I am sorry it took me a while to reply but I only have one computer which, when it's out action I can't reply. I am now back on the air again & hopefully staying that way.
    Many thanks again.
    Bligh.
      My Computer


 
Page 1 of 2 12 LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

İ Designer Media Ltd
All times are GMT -5. The time now is 05:12.
Find Us