Overheating laptop

Hello misago mate follow this
CLEANING A LAPTOP FAN & COOLER RAD
The thing you do is to turn over the laptop and shine a very bright light into the air intake aperture (you will see the fan there) and then while doing that look at the outlet vent on the end of the laptop you should see the light quite clearly shining through the cooling " radiator" if not - it is clogged and will need cleaning as will probably the fan opening.
You can do this by blowing it out using a compressed air can in short bursts.
BUT ONE WORD OF WARNING DO NOT blow the air into the fan opening without inserting say a plastic rod or large cable tie to stop the fan from spinning as the air blast will spin the fan at a very high speed that it is not designed to take and may wreck the bearing!!
To clean the slots in the radiator use a pipe cleaner or one of those craft covered wire sticks - they are referred to as chenille sticks - see pic. But do be very careful not to be overly heavy handed you will find it might take a second or two or a few minutes to clear the heavier build ups.

Ok mate yes it could be that too Lithium ion batteries do deteriorate over time but usually a lengthy time as my old Toshiba still has to original battery of six years.

Now having said that if that battery has been left to run absolutely flat quite a few times then that process can really age the battery ie shorten the working life.
There are plenty of reasonable priced batteries available EBay I know carries a lot.

If it were me I would redo the thermal compound on the CPU and GPU chips because they are the two most likely components that will cause the machine to heat up that quickly.
Now I don't know if you are confident enough to do that but it is like I said where I would start.

To give you a rough idea where I mean I have attached two pics and this is a typical laptop setup the compound goes between the chips and the heat spreader.

I purchased and have used for some time now for each laptop a usb-powered external cooling assembly [you can get these with one giant fan or twin fans]. In addition to what you do or decide not to do inside the laptop, having and using a cooling assembly really helps keep the temp down.

RolandJS said:

I purchased and have used for some time now for each laptop a usb-powered external cooling assembly [you can get these with one giant fan or twin fans]. In addition to what you do or decide not to do inside the laptop, having and using a cooling assembly really helps keep the temp down.

Yes now there is a god option.

misago said:

ICIT & Roland, Thanks to you both for the information. ICIT I think that procedure you described is probably beyond my comfort level but perhaps I'll open up an older laptop I have just to get familiar with those kinds of steps. The puzzling part of this is that the bottom of my machine is not hot at all. Only the air exit location (about 2 sq. inches) gets hot. Then all I have to do is reboot to cool. I just have a feeling something (malware program) is running when I get on the internet causing my machine to begin working hard and heating up. But I've scanned and nothing shows up. I've ordered a new battery, and will use computer sparingly until it arrives.

No probs misago mate let me know when you are ready to try your hand at disassembly and I can send some stuff I have made up for general hints. There is as you might imagine some very small screws, ribbon cables, and connectors inside laptops that need very careful handling and other little things like for example I always do this on a large white bath towel stretched over the work top to stop dropped screws from bouncing usually onto the floor never to be found again and also they can be seen easily on a white surface

Good idea of yours though is to get hold of a defunct laptop and take it apart anyway. Having said that some laptops are taken apart in some really awkward ways and have screws that are tucked away from view and some that need a complete breakdown to get inside but for the time being that is enough info.

The heat where you say it is is actually not uncommon and I would not worry about it unless it actually burns to the touch or starts to melt the surrounding plastics.

And, please get into place a usb-powered external cooling assembly [one giant fan or twin fans] -- $25-20, monies very well spent.