Bios settings for Gygabyte 299 for windows 7

I had my Win 7 working with my Gigabyte 299X. Now I can't even get into safe mode before it blue screens. What are the settings that I should have in my bios using windows 7?

Just to test this I made a new clean installation Windows 7 on another computer then moved the drive over to this one and it is the exact same error. This makes me think there is a BIOS setting that got changed. Any help would be greatly appreciated. Also a side question to UFI or not UFI?

I agree and thanks for the warm welcome. I have a good a Ron's backup of my setup so I can experiment .

I have been building computers for over 20 years and the regular non miserable enabled bios I could navigate very well. This is my first graphical one and I onow there has to be certain settings to make wi. 7 work while enabling other ones is guaranteed to break my windows 7.

So if I go non ufi what should my settings be?

- - - Updated - - -

I am getting the following BSOD

0x0007b
Oxffffs97c8
Oxfffffc0034

Any idea what could cause this error? Fix for it?

SIW2 said:

stop 7b is usually a driver
What are these files? How are they used? I am running Win7 64. The weird part is that I can take this drive out and put it in another computer and it boots up fine, finds the new hard ware and works. As soon as I put it back it BSOD again
does it say 0x0000007B (INACCESSIBLE_BOOT_DEVICE) or something similar

The funny part is that I can move this hard drive to a different pc and it works fine finds new hardware. Once I switch it back it goes back to BSOD

I also created a blank WIn7 on the problem computer and that works fine as well

- - - Updated - - -

It just days stop: ox0000007b (0xffffff88009a97e8,