Screen resolution broken?

If I knew I would simply tell you.

And bad news. I can't start Catalyst in remote desktop.

So you either have to look for it, or wait until I can access the HTPC.

The name of the option it's self is Overscan.

It's a disgrace what ATI has done to the UI since version 9.6

greetz

open catalyst control centre

right click top left(graphics)

then desktop and displays...then in bottom left right click the small moniter then right click it and click on configure , you should see scaling options menu
then walaa done





also wtf is the point of all this bull**** ATI i mean wtf

Gilly said:

open catalyst control centre

right click top left(graphics)

then desktop and displays...then in bottom left right click the small moniter then right click it and click on configure , you should see scaling options menu
then walaa done





also wtf is the point of all this bull**** ATI i mean wtf

k so it didn't fix

what happened is the screen filled up my whole monitor, but then it went back to being 1600x1200...

/shrug

FARR said:

k so it didn't fix

what happened is the screen filled up my whole monitor, but then it went back to being 1600x1200...

/shrug

try changing your resoloution to what you prefer usin ccc right click it on taskbar bottom right right click the icon then go to ure graphics card then go to set desktop area then choose 1 then go back to the overscan thing then click ok when moniter filled and see if that works

also if that dont work go back to the overscan page and tick the box "use the scaling value instead of the.... etc.."

Gilly said:

try changing your resoloution to what you prefer usin ccc right click it on taskbar bottom right right click the icon then go to ure graphics card then go to set desktop area then choose 1 then go back to the overscan thing then click ok when moniter filled and see if that works

i can't find overscan

have you followed the instructions about 4 posts up..

or try reinstalling drivers from here Graphics Drivers & Software

make sure you get the correct one for operating system and gpu model


i remember a while back i downloaded the wrong one and the overscan option was greyed out

I just can't seem to find overscan in the options, i right cilck and see configure, but there is no overscan anywhere near there.

myzr7 said:

where is the 3/4 inch of black located? all the way around or just on one edge? can you use the controls on your monitor to adjust that?

its to the left of my screen, its just one spot. and its the resolution that i don't want. I need it higher.. but i really don't want to formatt my drive and install windows 7 again..

FARR said:

I just can't seem to find overscan in the options, i right cilck and see configure, but there is no overscan anywhere near there.

its just the slider what says underscan ---overscan in scaling options menu