Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.


Windows 7: edit registry w/o Win 7?

04 Nov 2010   #71
GranPaSmurf

Win 7 Professional 64-bit
 
 

up & running. downloaded security & ccleaner & Chrome & drivers for dual monitors. I am going to hang it up for tonight. Back about 6 A
M


My System SpecsSystem Spec
.
04 Nov 2010   #72
karlsnooks

MS Windows 7 Ultimate SP1 64-bit
 
 

Good.
My System SpecsSystem Spec
05 Nov 2010   #73
GranPaSmurf

Win 7 Professional 64-bit
 
 

before we are done I hope you will teach me or tell me why Win7 denies access to my documents. I am the only user and I am the one and only administrator, but "access denied" ? In earlier installation I set my permissions, but why should I have to?
My System SpecsSystem Spec
.

05 Nov 2010   #74
karlsnooks

MS Windows 7 Ultimate SP1 64-bit
 
 

I have no idea what time zone you are in. I'm in Central Standard Time,CST.

Remind me about the access problem when all else is finished.

Would you make a snapshot of the present output of Disk Management?

Need that to correctly advise on next step.
My System SpecsSystem Spec
05 Nov 2010   #75
GranPaSmurf

Win 7 Professional 64-bit
 
 

I am just down the road from you, Universal City, just north of San Antonio. But I need another hour or so. I will be back to the systems around 2 pm.
My System SpecsSystem Spec
05 Nov 2010   #76
karlsnooks

MS Windows 7 Ultimate SP1 64-bit
 
 

OK.
My System SpecsSystem Spec
05 Nov 2010   #77
GranPaSmurf

Win 7 Professional 64-bit
 
 

I have a glitch. This is an older board, the SATA system will not see the 1 Tb drive. A couple of months ago when I bought the large HDD, I added a Silicone Image card to support the drive. It needed a bios flash which I did back then to see the drive. I had to redo that this morning. Now the large drive is visible in My Computer, but the Computer Management Console will not fully deploy the Disk Management. I reads at the bottom "Connecting to Virtual Disk Service...". Resource Monitor shows only about 2% CPU load. Also, Safe Mode refuses to get past "ClassPNP.exe" file.

Wait...the Disk Management shows now...
My System SpecsSystem Spec
05 Nov 2010   #78
GranPaSmurf

Win 7 Professional 64-bit
 
 

snip


Attached Thumbnails
edit registry w/o Win 7?-diskmanagement.png  
My System SpecsSystem Spec
05 Nov 2010   #79
seekermeister

W7x64 Pro, SuSe 12.1/** W7 x64 Pro, XP MCE
 
 

I only read a few of the first posts of the thread, so I don't know how germane it is, but I recently had a problem very similar to this...did you use Paragon Partition Manager? If so, in the future use something else. My boot hung at the login screen also, until I disconnected drive 0 (non-OS). I think that PPM was also involved in the failure of that drive, when I later attempted to delete a raw partition at the front of that drive.

Like I said, I only scanned the thread, but I think that you said that Drive 0 is your OS drive, and if that is the case, I'm not sure what happened, but it must have to do with MBR, or MFT corruption.
My System SpecsSystem Spec
05 Nov 2010   #80
karlsnooks

MS Windows 7 Ultimate SP1 64-bit
 
 

Sure wish you would check in with me before you take those plunges.

Let's see if we can recover without having to go back to ground zero.

Part of yo problem, if not all of it, is caused by having more than one active partition in your system.

What you need to do is:
1 Boot up from that System Repair Disc.
2. Go to a command prompt and run
3. DiskPart
4. type List Disk
5. type select disk n where n is the number that correponds to one of the drives which your disk managment shows as being "active.
Right now you have three drives marked as active.
We only want one, the C, to be active.
6. OK you selected one of those other active drives.
7l type Detail Disk
Read what is there and make sure you got one of those two extra active drives.
8. type Select Partition 1 (since on the disk, partition 1 will be the first one)
9. type INACTIVE
10. Repeat this for the other drive that was marked active that shouldn't have been.
11. when finished, type Exit
12 remove the Repair Disc,
13. type exit
My System SpecsSystem Spec
Reply

 edit registry w/o Win 7?




Thread Tools




Similar help and support threads
Thread Forum
Edit the Registry to Restore Security Tab ??
Hi all, I'm helping someone out with a problem. They seemed to have lost their security tab in Explorer Properties when they right click on their Storage Drive... i.e. E:/. I have tried going through the local group policy editor... gpedit.msc and setting the "Remove Security Tab" to...
System Security
Windows 7 Slow after registry edit
Hi everyone, I have edited the registry remotely on an machine on the network, to add the followings to the registry. Windows 7 32-bits pro Everything worked perfect, but after login, the machine takes longer than expected with a black screen. It happened on 3 other ones too. Windows...
Performance & Maintenance
registry edit from old windows install
I recently upgraded all my hardware, and did a fresh install on a new hardrive. I kept the old windows on another drive. My problem is I had to reinstall a plugin I purchased less than a year ago, and the company has disappeared (pluginlab), they used an online tool to activate software, and this...
General Discussion
BSOD registry edit
hi guys, a week ago i i got helped with a BSOD problem by changing some registry keys. I did it by puting the harddrive in another computer that was able to boot the harddrive. The problem i have now is that the hardrive wont boot on any other PC I put it in but i can access it if i boot from...
BSOD Help and Support
Edit Registry - uninstalled software
Hi, uninstalled Nero 7 on my machine. Checked the registry and lots of key entries left over. Under HKEY_CLASSES_ROOT there are 90 key references beginning with Nero. Under HKEY_CURRENT_USER - Software- Ahead I have 17 entries under Ahead and each of these entries has sub key entries. Under...
Performance & Maintenance
Auto Arrange Fix (Registry Edit)
Hello, For all of you Windows 7 users who have been annoyed (like myself) at the removal of "Auto Arrange", a fix has been discovered. It was discovered by Ramesh Srinivasan @ How to Disable Full Row Select in Explorer in Windows 7? - The Winhelponline Blog (Taken from the site) Iím...
General Discussion


Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd

All times are GMT -5. The time now is 17:51.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App