New
#11
You too :)
Some motherboards in my experience do not handle upping voltages very well. It can cause serious problems if a motherboard doesn't implement it very well or isn't really designed to run memory at a certain voltage.
Again, it's probably not going to hurt anything. But it can, even if by user error mucking around in the BIOS, and I don't see any real gain by overriding the motherboard. Memory only makes a noticeable difference with varying capacity, but memory speed and latency rarely are worth bothering with, especially on the Core 2 line, which aren't very memory sensitive at all. ANd if he isn't upping the voltage to better any of these, it matters even less.
I'd only recommend upping the voltage if the memory is unstable at a lower voltage, but not just because it's rated at 2.1V.
I am watching vids on youtube about my motherboard. I think you and I both have quality motherboards and we can probably bump out voltage up to spec. I looked at your specs and you have a nicer one than me and mine is highly rated. I am not going to worry much about it. I think the quality of the board has a lot to do with it.
Does Intel advise voltage for RAM? I am not familiar with Intel specs on RAM. If you know where I can find them let me know.
I just flashed my BIOS so I'm not scared of a little voltage on the RAM. haha
Not usually.. in the case of the Core i7 965 EE, I know they say anything above 1.65 can burn out their chip. Yikes. I believe it's because the chip, RAM, can be OC'ed so easily.
I see....Thanks for the info. I am reading about OCing. I know when you change the Mhz on the cpu, it affects the RAM so it would make sense the other way around. Or is it just on i7s?
I've yet to do an overclocked i7 build. However, on most CPUs, frequencies are a multiplier of a bus (e.g., 266mhzx9 for the Q6600) and raising the bus frequency 1 mhz will raise the cpu frequency by 9 mhz. On some motherboard the RAM is linked to this same bus and thus is a multiplier of it, but on others, you can unlink the two and manipulate them separately.
So on a board where they are linked, then increasing RAM frequency would increase CPU frequency and vice versa. I don't know a huge amount about overclocking though, so my details might not be great.
Well I have a pretty good Gigabyte board and I have bumped my RAM voltage from 1.8 to 1.94 It has not affected my CPU and my RAM says on the sticker and the box to give it 2.0-2.1V
That's the reason for this thread, to find out if it's a good idea
I have found since starting the thread that most boards are set to 1.8V for RAM just in case you have 1.8V RAM......you are supposed to adjust the setting to what your ram needs. (on my board EP45-UD3P)