New
#1
Changed PSU,when connected 24pin,no power
Hey guys
I exchanged psu's in my computers due to cable needs,and i have replaced a 500w antec with a 500w northq (NQ-4775-500s), now,i tested the psu with a multimeter,and all is a-ok across the board, however,whenever i plug the psu into the motherboard (Gigabyte GA-H55-UD3H), 24pin and 4pin 12v atx nothing happens, no fans start spinning,no light on mb,nothing. I can get fans spinning and everything if i short out the power and ground on the 24pin connector,but when same is connected to mb,nothing happens.
Now,this motherboard worked absolutly fine with the antec psu. The antec had a 8pin 12v atx i needed on another pc,and this gigabyte mb only need a 4pin 12v atx,so it should be a perfect fit.
Anyone have any ideas? Other than the mb suddenly is fried or something