New
#61
Just a thought.
What are your cpu temps under load with your over clock?
What are your vCore volts under load with your over clock?
Usb code 10
-
-
New #62
Hi with HW monitor MAX temp was 62. Vcore about 1.36
-
-
New #64
wireless
Hi,
Your wireless WILL have the advanced tab, and a lot of them have
Gaming mode enable/dissable.
Post a screenshot if not.
Roy
-
New #65
Well i increased my CPU voltage from 1.12 to 1.13 seemed to
Do the trick :)
-
New #66
From post #62
From post #65Vcore about 1.36
If you would answer my questions completely, I might be able to help you.Well i increased my CPU voltage from 1.12 to 1.13 seemed to
Do the trick
Your cpu volts are what at what load or are the readings at idle.
-
New #67
That was at full load. I use Nick N guide hes a guru best at OC haswell ever. Can't beat this guy.
Haswell: 4.8GHz on Air.. Building A Haswell System - SimForums.com Discussion
-
New #68
Okay. Watch your vcore and temps. At a 4.8 over clock your vcore (cpu volt) might have to be bumped up just a little.
The rule of the thumb is keep you vcore as low as you can without a BSOD and everything working properly; and yet keeping the temps under control.
-
New #69
His guide goes up to 4.8 GHZ but i'm only clocked at 40 thats good enough for me!
-
New #70
So can a wrong cpu volt cause USB instability? I think going to 1.13 has sorted it out will keep testing though for a few days to make sure!
Quote
Related Discussions