embarrassed but need help identifying motherboard

Asus usually uses AMI (American Megatrends) BIOS. What CPU is in the board? Also, can you tell us what writing is on it? The model is usually on the board somewhere. I don't know of a 1 long and 2 short beep code, but it has a 1 long 3 short beep code that is memory related. Are you able to enter BIOS? If not, I would check make sure the ram is in the correct slots and re seat it and try again. If it will post,

Please Run Memtest86+

   Information

Please download from this site only http://www.memtest.org/ in the middle of the page are the Download links, you can download the ISO.zip or the Auto USB Flash Drive installer.zip

Extract the Zip file. If you chose the ISO image, burn it to a CD using Windows Disk Image Burner or any Image burner you may have. If you downloaded the Auto USB installer, extract it, insert your USB 2.0 Flash Drive and take note of the drive letter. Run the installer, select the Flash Drive Letter, check the format box and press next. It will install memtest86+ to a flash drive. You can use either V4.20 or V5.01. Boot from your selected media. If you use V5.01 it will tell you to press certain buttons at the start, please press no buttons. The test will begin on it's own and continue to run until you stop it. It needs to run for 8 complete passes or until you receive an error. If you receive an error, stop the test. Even 1 error is a fail. Each pass tests a different part of the ram and each of the 10 tests in each pass tests something different. It takes a minimum of 8 passes to completely test the ram, more passes are better. It is quite a long test and will take several hours depending on how much ram you have. Due to the time length it is best to run overnight. If you have any questions, please do not hesitate to ask

My two Asus motherboards have a small white sticker on the lower right that have the needed I.D. numbers. They are very small to read.
I have to use a magnifying glass to read them.

A picture straight down of the mobo will allow us to locate the information, removing any GPU or sound cards will also help.

Hi,
Yep my manual says 1 long and 2 short beeps means no memory detected.

Viscon said:

to identify your mobo you can also use Aida64
download trial from here:
Downloads | AIDA64
install and load, then on the right pane open up "Motherboard" / "Motherboard
on the left pane look for "Motherboard name" entry (second from the top)

He can't boot.

trinaz said:

Thanks guys....should have mentioned this in original post...this same board ...no changes on anything...worked flawlessly in my old Win 7 Pro box (#1) prior to Win 10 clean install last week in #1....moved board intact with same video card-memory-cpu etc to box #2 - 1 long beeb-2 short. Have reset memory - GT 630 - after moving to box 2 - still same issue...1 long 2 short bios beebs and no joy after that

Will check on cpu later today and motherboard info with my magnifying glass (photo too)...but this same board as is worked fine in box #1 prior to upgrade MB/Mem/CPU of box #1 last week ?

Thanks....TiminAz

Uploading a photo here won't hurt, it will just make it easier for us to help you! :)

When you moved the board, did you remove the ram, CPU and CPU Cooler?

Strip the board down, to 1 stick of ram, the on board graphics, no Hard drive or DVD. Nothing attached but keyboard and mouse, and try to boot. Nothing attached except what is required to post. See what happens.

Recheck you power supply connections making sure the correct wires are attached and that they are completely seated in the correct places. Are you sure the ATX 12V EPS at the top of the CPU is connected and fully seated?