[fspsyco]

Woohoo it worked I got video

[essenbe]

OK, good luck.

[fspsyco]

I got into bios set the time and date set, I also set system defaults 2 things the cpu temp read 45 degrees celcious on my other pc it was in the lower 30's also the fan rpm text was in red running over 1750 rpm

[essenbe]

I'm glad it worked. That is too hot for the CPU at idle. You can clean and reapply the paste and cooler without removing the CPU! If that's what is needed. Check and make sure the CPU cooler is firmly attached.

[fspsyco]

Yea a couple were loose but for some odd reason when I powered it on afterwards the temp got higher

[fspsyco]

Would too much paste cause this?

[essenbe]

Yes. The video I showed you shows the right amount. 1 blob in the middle, between the size of a pea and an uncooked grain of rice. Let the pressure of putting on the cooler spread it. Make sure the old piece is perfectly clean, both the CPU and the cooler.

[fspsyco]

I have re applied the paste 3 times now and I can't seem to get it lower than 45

[fspsyco]

In fact the temp rose to 55 after a few min

[fspsyco]

This good?