2 TB external HDD CRC errors. CHKDSK stuck for a long time.


  1. Posts : 1
    Windows 7 Home Premium Service Pack 1 64 bit
       #1

    2 TB external HDD CRC errors. CHKDSK stuck for a long time.


    I have a 2 TB Seagate external hard drive that I've been using since 2014 (requires wall adaptor for power). It has been running fine for all these years until a few days back.

    I backed up 753 Gigs of data (5055 files) from it out of which 10 files could not be copied due to Cyclic Redundancy Errors.

    I decided to run CHKDSK to fix the errors, which has been running since yesterday and this is the current state (in the pic).

    It has been stuck at 8044 files since this morning, do I abort now or let it run? The hard drive is still spinning and the activity light is blinking.

    Should I try a running CHKDSK using CMD instead?
    Attached Thumbnails Attached Thumbnails 2 TB external HDD CRC errors. CHKDSK stuck for a long time.-whatsapp-image-2017-05-23-5.24.07-pm.jpeg  
      My Computer


  2. Posts : 7,055
    Windows 7 Home Premium 32 bit
       #2

    It is very clear that your Drive has developed many bad sectors. It is no longer reliable. You can abort check disk.

    You have already recovered some 753 GB of data. Is that all that you want? Can you forget those 10 files that you found you were unable to copy?

    In that case run Seatools for Windows and check the health of your HDD. If it could repair and give a pass well and good. If the tests fail discard the drive.

    In the other case, if you want to recover more files/try and recover those 10 files which Windows says is corrupted,you can create a Live Linux pendrive, boot from it and check your luck.

    My post #8 here Is there any way of saving a completely unrecognisable hard drive?
      My Computer


  3. Posts : 15
    win7 ultimate x64
       #3

    There is no software like pctools today?
    To mark bad sectors, to reevaluate them.
    Only to find them.
    I used recently minitool with aimei partition tool (both are needed at the same time) to avoid freeze problem with bad sectors.
    Aomei has ability to unshock itself after abort check of bad sectors disk.
    That is used to find and isolate bad sectors if there are less than 10 in small partition.
    You can try and succeed to use seatools for dos (i dont know that seatools for windows work bad sectors check) but i didnot have time to do that...
    For 2 TB disk it is a lot of time....over a day probably...

    This is approach to use disk, not save data...
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 15:34.
Find Us