Windows 7 Forums
Welcome to Windows 7 Forums. Our forum is dedicated to helping you find support and solutions for any problems regarding your Windows 7 PC be it Dell, HP, Acer, Asus or a custom build. We also provide an extensive Windows 7 tutorial section that covers a wide range of tips and tricks.

Windows 7: Power Supply Pinout +5VDC

26 Jul 2017   #11

Windows 7 guest, Debian host

Quote   Quote: Originally Posted by mjf View Post
PSU capacitors can store lethal voltages for some time after the PSU has been disconnected.
Yes, I can discharge it by a few ohms resistance.

Quote   Quote: Originally Posted by fireberd View Post
Everything in the computer is dependent on proper voltages and adequate amperage (power).
That's the reason should have a data sheet specification.

My System SpecsSystem Spec

 Power Supply Pinout +5VDC

Thread Tools

Similar help and support threads
Thread Forum
Bought new Power Supply Unit, won't power on. Did I buy the wrong one?
I have a Corsair CX430M PSU with 4 slots to connect in the back. CORSAIR CX series CX430 430W ATX12V v2.3 80 PLUS BRONZE Certified Active PFC Power Supply - & bought a new Antec BP550 Plus PSU, which has 5 slots to connect to. Antec BP550 Plus ATX12V V2.2 80 PLUS Certified Modular...
PC Custom Builds and Overclocking
Power Supply
Hi My neighbor brought her laptop over its dead (HP Pavilion g series)I think maybe her charging brick is bad, can I try my charging brick (Asus G75) to see if its takes a charge. The numbers are different on the brick than hers will that make things worse ? HP---input 100-240V 1.7A ...
Hardware & Devices
Hardware Power Consumption-Picking a new Power Supply
Ok, so it's time again for me to pick a new power supply, however, I'm in need of some help determining the appropriate wattage for my hardware setup. AMD Phenom II X4 955 45nm AM3 GSkill Ripjaw X 16.0 GB Dual-Channel DDR3 @ 668MHz (9-9-9-24) Corsair TX750w (I dont think its the V2) ASUS...
Hardware & Devices
Power Supply
I just installed a new power supply in my computer today. My original bad one had about 3 SATA power connectors. I only need 2. I have my hard drive powered up obviously, but the two connectors on the new PSU are too close together to reach. Is it possible to cut one of the connectors...
Hardware & Devices
Power Supply
I had my computer built in January 2008. In early 2009, I had to have a new power supply which I had installed at a different place from who built the system. My computer is in the shop again having another power supply put in. I am not sure what quality psu was in it, but I have asked to have a...
Hardware & Devices

Our Sites

Site Links

About Us

Find Us

Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd

All times are GMT -5. The time now is 20:47.
Twitter Facebook Google+ Seven Forums iOS App Seven Forums Android App