XBCD drivers for Xbox 360 gamepad

i expect you are missing a character set that the tool depends on.

Hi leonhart,

I have a little question... I'm willing to reduce the sensitivity of an axis. I can do it if I modify the "scaling" in my XBCD profile (from 100 to 85 for example), but then I won't be able to steer at 100% (it's for a racing game).

I checked the ingame options, and I can only set a higher sensitivity there, that's why I would like to do it through XBCD.

Any ideas ?
Thanks,
Revo

Range is not the same as sensitivity

infact reducing the range increases the sensitivity when the control is recalibrated for the new range.

marcus2976 said:

I aint having no luck getting this to work i have followed everything to the "T" and i am having no luck at freakin all can someone please help me out I have a Afterglow AX.1 Wired controller for Xbox 360 wanting to use it on my pc so I can play Alpha Protocol and Prince of Persia The Forgotten Sands also.



This it what it shows in the Device Manager:

The drivers for this device are not installed. (Code 28)
There is no driver selected for the device information set or element.

To find a driver for this device, click Update Driver.

That control is not supported, i need the PID and VID numbers to add it.

squall leonhart said:

marcus2976 said:

I aint having no luck getting this to work i have followed everything to the "T" and i am having no luck at freakin all can someone please help me out I have a Afterglow AX.1 Wired controller for Xbox 360 wanting to use it on my pc so I can play Alpha Protocol and Prince of Persia The Forgotten Sands also.



This it what it shows in the Device Manager:

The drivers for this device are not installed. (Code 28)
There is no driver selected for the device information set or element.

To find a driver for this device, click Update Driver.

That control is not supported, i need the PID and VID numbers to add it.

Here are the numbers that you asked for :

USB\VID_1BAD&PID_F900&REV_0100
USB\VID_1BAD&PID_F900
That is the numbers that are under the hardware Id list i hope that this might help in any way Thanks

ok, file updated. same links

Hey, I'm the one a few posts up that was having the problem with the game's configuration showing ??????'s everywhere. I uninstalled/reinstalled the software and it looks correct now. I ran ffxiconfig and enabled gamepad/assigned the buttons. When I test the gamepad, the buttons work perfectly, including the triggers. However, my analog sticks aren't working correctly.

When I click the movement tab for its assignment, it gives me one of those "Hold the directional control device in the <UP> direction and press button 1." kind of deals until I've done all of the directions. So I went through the steps with my left analog stick. Then I did the same thing with the right analog stick for the Camera. I finished with Menus and using the control pad.

When I test the gamepad, all 3 (movement box, camera box, menu box) move with the left analog stick, and none of them are even close to being correct. Do you have any ideas on what might be going on? I move the right analog stick and none of the boxes have movement.


I hope this makes sense to you and thanks again for all your help.

Not sure if this will help you bgbffloch.

maybe, Go to control panel and under your xbox controller, try recalibrating it.
bgbffloch