Now I have downloaed the right copy of Win 7 7264 x64 But
When I try to install it it gets to the the compatibility check it should come up with a couple of things but it comes up with a blank page
an will not go any further there are no buttons for next etc
& when I click cancel it just goes back to the start again it just go around in circles
any idea what wrong with my copy ??
Hi Gaz, just had a thought.
What speed did you burn the DVD? I recommend using anything 4x or lower to reduce burn errors.
No I just unzipped it to my desktop and install from there it normally works but this time it hasnt
You may need to edit a file...
Go to the folder you extracted to and then to sources, then open up cversion.ini & change the contents/numbers to lower than the build your trying to upgrade. It could be that during the compat check that the cversion.ini is kicking it out.
You could alsy try running the setup.exe in 'compat' mode for Vista as that has been reported to work in some cases.
Jeff
funny how things just pop into my head
I am now buning it to see if that makes any difference
This is what it has in the Cversion ini
[HostBuild]
MinClient=7233.0
MinServer=7100.0
What should I change it to????
I thought it should have 7264 there???
Came up with the same thing
But this time there was a next btton there so its installing as im typing
Please see atachment too
Have you run the setup.exe file with 'Compat' mode for Vista? Might be worth a try.
Also, are you running the setup from a seperate partition or HDD?
Quote