New
#41
Read the bottom of the screen when you first turn on your PC. There it will tell you which key to push to get into the BIOS. basic input/output system (BIOS)
Usually F2 or delete.
Will have a read of the manual, any idea's why I need to disconnect/remove a Hard Drive?
So it doesn't interfere.
It would be good to know the SATA controller setting first. Did you check yet?
If you can change the setting to AHCI you can try install again now and it might work.
If not disconnect a HD to try it.
Then wipe the target HD to try again.
Recall I explained that in your first thread? What Device shall I get for £70
To avoid the chance that system files get written to the 2nd HDD.
Regards,
Golden
You do not have to remove any drives, just disconnect the power from one.
On Sata Config from BIOS
It gives three options:
RAID
AHCI
IDE
RAID is default, but I broke the RAID a few days ago.
Shall I change to AHCI?
Yes, what is the setting now?
It is raid now, shall I change to AHCI?
After changing to AHCI, what do I do now?