New
#1
C Drive Connected to Motherboard SATA Connector 3 Instead of 0.
Hi...my Intel SSD which is my OS-C drive is connected to the motherboard SATA connector designated as SATA connector 3. On initial install of W7 I had a problem where the MBR was installed on my internal N drive (connected to motherboard SATA connector 0 ) instead of on same drive as OS.
I have sorted out the problem some time ago so the MBR was migrated to the same drive as the C drive. That problem sorted out.
What I need to know is are they any problems/consequences with my OS-C drive being on motherboard SATA connector designated as SATA connector 3 rather than in the traditional position of using SATA connector 0 on motherboard for C drive ?
Also if I swap them around so C on 0 & N on 3 on motherboard; will this cause any problems, and will the PC boot up as normal with C being disk0 and N being disk3 within the Computer Mgt Window ?
Should point out PC is running fine without any obvious problems.
Thanks in advance.... Gary