My Monitor is not showing anything when i press the start button


  1. Beelo
    Posts : 3
    Windows 7 Ultimate x64
       New #1

    My Monitor is not showing anything when i press the start button


    after i was trying to upgrade from windows 7 to windows 8 i restarted my computer to try to upgrade it then when i pressed on the start button nothing showed up ( the screen was black ) and i usually get a "beep" when the computer turns on but this time i didnt ( i can hear the fan is on ). And i tried to connect my monitor to another computer to see if the monitor is the problem but it worked. ( im using my laptop to post this )
    Thnx for reading



    Regards, Beelo
      My Computer
    Quote Quote

  3. HarriePateman
    Posts : 3,904
    Windows 7 Ultimate 64-bit
       New #2

    Can you describe the beep, was it long or short? was there 2 or even 3 beeps?
      My Computer
    Quote Quote

  4. gregrocker
    Posts : 50,642
       New #3

    Are you getting BIOS post screen? What happens if you tap the BIOS setup or Boot menu key at startup?

    Can you try another monitor?
      My Computer
    Quote Quote

  6. Ztruker
    Posts : 6,285
    Windows 10 Pro X64
       New #4

    May be caused by defective memory. Try removing 1/2 the memory and see if it will boot. If not, swap the memory and try again. If it boots either time then replace the defective memory SIMM.
      My Computer
    Quote Quote

 

  Related Discussions
I've got a 1-2 years old Dell XPS-8300 pc and when I press the button to open the disk (CD) drive nothing happens. The only way to open it is using the Eject function on the computer which is a bit long-winded especially as the Format function is next to it. Oddly if it's already open pressing the...
Whenever I press the media button on my remote, my Xbox starts up. Is there anyway I can stop that short of putting some tape over the IR receiver on the Xbox when I'm not using it?
On bootup on my Win 7 64-bit desktop nothing appeared on the monitor , just a completely black screen . I realise this could be due to several causes - monitor failure , video card problems etc and I have yet to check these out but my reason for posting here before I do these basic checks is...
I have two new Windows 7 computers (laptops) that I run 3D design software on. I have multiple programs that utilize a simultaneous pressing of both left and right mouse buttons (not double-click). This command goes unrecognized in my software and is used extensively to go into 3d rotational...
Hi, When I press Sleep button, I expect Windows to get into sleep mode at once. But why Windows spins up CD/DVD drive? This is very annoying, since I am putting my laptop to sleep mode several times a day. Thank in advance for any help. avgfk
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 06:10.
Find Us