Wiping Out Everything on Dell XPS 8100 Desktop

Page 8 of 20 FirstFirst ... 67891018 ... LastLast
  1.    #71

    Yes you still must boot the stick.

    Do you notice any EFI Boot choices?
      My Computer


  2. Posts : 657
    Windows 10 Pro
    Thread Starter
       #72

    I put the stick back in and then restarted the computer.


    Right now its back to the install windows again....
      My Computer


  3. Posts : 657
    Windows 10 Pro
    Thread Starter
       #73

    Where do u want to install windows


    disk 0 unallocated space 465.8gb total and free. Then clicked driver and then put 240000mb and i see same thing like last time


    disk 0 partition 1 234.4gb

    disk 0 unallocated space 231.4 gb
      My Computer


  4. Posts : 657
    Windows 10 Pro
    Thread Starter
       #74

    gregrocker said:
    Cancel install and Shut down to unplug stick.

    Wiping the hard drive most often solves these issues so you can skip to Step 6 after booting stick to run Commands to see if that helps. Windows 7 Installation Failure - Overcome

    How am i suppose to do this? You want me to hold on to power button to shut down right? Then unplug the stick. Then power on again? Yet if i do this, wouldn't the first thing that show up is that boot error? Or am i suppose to press f12 the moment i power computer again...


    srry very confusing.
      My Computer

  5.    #75

    If you cancel the install and are observant you will see restart or Shut Down choices.

    Otherwise press the power button once to power off in boot mode.

    Obviously you need to tap the boot key at first screen
      My Computer


  6. Posts : 657
    Windows 10 Pro
    Thread Starter
       #76

    Is the boot f2 or f12?


    If you cancel the install and are observant you will see restart or Shut Down choices.


    I cancelled the install twice. There was no option of restart or shut down. When you click the x button it automatically restarts...
      My Computer

  7.    #77

    Restart is good enough.

    F12, same as when you booted it before a few minutes ago.

    Look for any EFI choices and report back
      My Computer


  8. Posts : 657
    Windows 10 Pro
    Thread Starter
       #78

    Please select boot device

    Cd/dvd1-hl-dt-st DVD+/-rw gh5
    RAID: WDC WD5000AAKS-75VOA
    Diagnostics
    Boot to utility partition
    enter setup
      My Computer

  9.    #79

    Enter setup to reset to defaults, save and exit.

    I don't see flash stick listed. Boot it to run commands.
      My Computer


  10. Posts : 657
    Windows 10 Pro
    Thread Starter
       #80

    gregrocker said:
    Enter setup to reset to defaults, save and exit.

    I don't see flash stick listed. Boot it to run commands.


    Im suppose to have the flash stick in the computer? I didnt have it in when i did this...
      My Computer


 
Page 8 of 20 FirstFirst ... 67891018 ... LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 07:40.
Find Us