copy protection message using same TV


  1. Posts : 10
    Windows 7 Ultimate 32 bit
       #1

    copy protection message using same TV


    I have windows media center set up with a cable card and a Hauppauge DCR-2650. It frequently generates a message saying the program is copy protected and must be viewed on the same TV. It is only connected to one Sony TV by a HDMI cable. Of course most of the time, the power to the TV is off when a scheduled recording is being done.

    The computer is running Windows 7 Ultimate.

    The channels being recorded are local broadcast channels (available off the air) but are being viewed through Verizon FIOS.

    Is there any solution for this?
      My Computer


  2. Posts : 10
    Windows 7 Ultimate 32 bit
    Thread Starter
       #2

    fourced solution


    As it seemed there was no one with a solution, I took the ultimate approach. Reload everything on a re-formatted disk. This time things worked differently. Everything appears to work. I even have the DCR-2650 apparently always connecting when the computer comes out of sleep by powering the DCR-2650 when the computer goes into sleep.

    I think the fact that a hauppauge 1600 had been installed on this system caused some problems when the DCR-2650 was installed.
      My Computer


 

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 21:31.
Find Us