Has anyone here got the Samknows router setup?

If you have what's the ip address for loggin in? Thanks 1stly!

Hello Runkle,

You should be able to open the Network and Sharing Center and click on the See full map link. This will open the Network Map where you can hover the mouse pointer over your listed router to see it's IP address and/or click on it to actually open the router's log in page in your default web browser.



Hope this helps,
Shawn

This is what I get when the router is on the network...

See if refreshing (F5 or Alt+V+Refresh) that window a few times, or restarting the computer and trying again may help get the map.

Brink said:

See if refreshing (F5 or Alt+V+Refresh) that window a few times, or restarting the computer and trying again may help get the map.

Thanks for your help Shawn but no go on F5...Or reboot...apparently it is something to do with LLTD

I found this that may help.

http://fcc.samknows.com/faq.html

Review and Installation of NETGEAR WNR3500L Wireless-N Gigabit Open Source Router (Page 1 of 2): MyOpenRouter

Router is suppose to be the Netgear WNR3500L.

Log in info:
Router and Networking FAQ

Brink said:

I found this that may help.

http://fcc.samknows.com/faq.html

Review and Installation of NETGEAR WNR3500L Wireless-N Gigabit Open Source Router (Page 1 of 2): MyOpenRouter

Router is suppose to be the Netgear WNR3500L.

Log in info:
Router and Networking FAQ

Ohhh Shawn thanks mate... But, I have a Linksys WRT160NL That's why I am finding It so hard to find the ip address....Cheers

What it's not

192.168.1.1-3
192.168.2.1-3
192.168.3.1-3

Did you get it through the SamKnows/FCC Speed Test project?

Runkle,

Strange, it should be 192.168.1.1 according to the product page and manual for it below. Did it not come with any paperwork, or a number or site to look it up at? Since it's a FCC Samknows version, it may have been changed when they modified it.

Product page:
Linksys by Cisco Wireless-N Broadband Router with Storage Link WRT160NL

PDF manual:
http://downloads.linksysbycisco.com/..._UG_NC-WEB.pdf


See if this may help.

How do I get access to my unit's configuration page?

Your unit can be accessed by browsing to http://www.routerlogin.net on a PC currently connected to the unit, be it by wireless or by direct ethernet connection. You will be prompted for a username and password - please use "admin" and "password" to log in. We strongly recommend you change the password to something secure once you've logged on to the device, via "Set Password" under "Maintenance" on the left-hand side. If your Samknows unit is currently in bridge mode, please use http://netgearsetup.samknows.com instead.