Windows management instrumentation ( WMI ) information corrupted


  1. junky scientist
    Posts : 13
    Windows 7 ultimate 32bit SP 1
       New #1

    Windows management instrumentation ( WMI ) information corrupted


    The sharing tab of USB-KEY Dial & Dial-up connection properties says " WMI Information corrupted . Use system restore ."
    Windows management instrumentation ( WMI ) information corrupted-capture-_cleaned.jpg


    After restoring to earlier restore point , an error message comes saying " System restore did not complete successfully "
    Windows management instrumentation ( WMI ) information corrupted-capture_cleaned.jpg


    Please help !!
    Last edited by junky scientist; 18 Nov 2011 at 09:27. Reason: Typing error
      My Computer
    Quote Quote

  3. Maguscreed
    Posts : 6,668
    Windows 7 x64
       New #2

    Sounds like you have things pretty well borked.
    Do you have a windows 7 disc available for use?
    If so this might be your easiest out.
    Repair Install
      My Computer
    Quote Quote

  4. junky scientist
    Posts : 13
    Windows 7 ultimate 32bit SP 1
    Thread Starter
       New #3

    Unfortunately I don't have Windows 7 disc . Aren't there any other possible ways ?
      My Computer
    Quote Quote

  6. Maguscreed
    Posts : 6,668
    Windows 7 x64
       New #4

    I could if I knew what was causing it, but it could be your hard drive failing, corruption caused by malware
    There are a lot o possibilities to the source of your problem.

    Could you give me some more specific information about this usb dialup device?
    Make / model
      My Computer
    Quote Quote

  7. junky scientist
    Posts : 13
    Windows 7 ultimate 32bit SP 1
    Thread Starter
       New #5

    I guess my Hard disks are OK . I had full scan an hour ago and deleted 5 malwares !! The USB KEY Dial is " ChinaNet Client " Version 2.1.0 Shown below
    Windows management instrumentation ( WMI ) information corrupted-capture_cleaned.jpg

    Thanks :)!
    Last edited by junky scientist; 18 Nov 2011 at 13:27.
      My Computer
    Quote Quote

 

  Related Discussions
Hello all. I have recently done a repair install to fix an issue with Windows Media Player. But before that, I had changed the C drive or partition to active, and have read just now that the system reserved part should be marked active. 252112 Can I switch it back to active without anything...
I have never needed to use the Windows Management Instrumentation CLI before and i am unfamiliar with the syntax. Has anyone ever seen or written a tutoral for the WMI CLI before?
Power Management completely corrupted.
in Performance & Maintenance

Hello All: I just found out the power management components on my desktop has become completely corrupted. I have a Dell desktop runnin win 7 x64. When I go to Control panel, the Power Options original icon is missing, when I click on Power Options, I get essentially a blank window. Please see...
When trying to view my disks in Computer Management>Disk Management, I get "Connecting to Virtual Disk Service" for several minutes, then "Loading disk configuration information" nearly forever. After about 20 minutes, some information appears, but I can't scroll the window to see all the data. ...
Hey all, I have a problem that started a few months back which I *finally* traced to the Windows Management Instrumentation service. In a nutshell, when I would launch Windows Explorer, the first problem is that it would immediately become non-responsive for about 20-30 seconds. Then once back...
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 17:17.
Find Us