New
#1
How to set up a dual Ethernet card internet sharing with HT receiver
When building my Hifi mancave, I was smart enough to wire it for Cat6, etc, but not smart enough to put a few lines of cat 6 into my HTPC jack. So I only have 1 cat6 line into my computer area. My new receiver (Onkyo TX-NR809) has a ethernet port in it, which enables internet radio, media sharing, playing, firmware updating, etc. Being a techy guy I got another netcard and put it in my computer and I want to share internet to the receiver via LAN2.
I've been scouring the internet trying to figure out how to do this with Windows 7x64 to whatever system (probably linux based?). I've seen how to do it with Win7&XP, XP&XP, Win7&7 linux & Windows, and they all use some sort of "brige internet connection" or something like that, which doesn't apply to my situation. Will someone just tell me what IP stuffs to use for the following:
Lan1 (Comes from router & modem) It's set for DHCP now, but I can do manual:
IP: 192.168.0.100
Subnet: 255.255.255.0
Gateway: 192.168.0.2
DNS1:
DNS2:
Lan2 (Crossover/patch cable to Receiver)
IP:
Subnet:
Gateway:
DNS1:
DNS2:
Reciever:
DHCP Yes/No
IP:
Subnet:
Gateway:
DNS:
here is my setup:
Internet sharing is setup for LAN2: