Problems setting up Netgear N600 - Need help


  1. DannyDays
    Posts : 1
    win7 pro 64-bit
       New #1

    Problems setting up Netgear N600 - Need help


    Hello,

    Just got a refurbed N600 (WNDR3400) and it came without the Install Wizard. I have a TP-Link modem that connects to the ADSL fine.

    If I plug the PC and the modem RJ45 cables into two of the data ports of the N600 I can access the Internet just fine, but I cannot access the N600 firmware.

    The suggested logins from the Netgear site all time out
    http://192.168.1.1 or http://192.168.0.1 or http://www.routerlogin.net or http://www.routerlogin.com

    If I plug the modem into the yellow port on the N600 it comes up with "Connecting through WAN Miniport (PPPOE) and just hangs. Eventually quits with an error 651

    I did some searching and found one suggestion to use Telnet so I activated Telnet on this PC it and tried that in a command prompt with 192.168.1.1 and it timed out with an error "could not access via port 23."

    I am at the end of my knowledge here. :)

    Thanks for any help
      My Computer
    Quote Quote

  3. 2xg
    Posts : 2,377
    Win7 & Win8 64bit
       New #2

    Welcome to Seven Forums,

    Have you done a hard reset of your Netgear router?
      My Computer
    Quote Quote

 

  Related Discussions
Should be easy!.... But I cannot get my NEW Netgear N600 router to communicate with a NEW Netgear WN 3000 RP extender. The instructions say to press the WPS button on the extender then the WPS button on the router. No WPS button exists on the router! The instructions also I can use any...
Hi All I have just installed a Netgear WN3000RP Wireless range extender and Netgear N300 Wireless USB Adaptor. The USB Adaptor shows as having WPA2-PSK Security but the Extender only shows as having WPA-PSK Security. This is probably something I did when installing. Is there any way to alter...
Hey everyone, The drivers for my WG111 won't work with win7 rev 7000. It says they are unsigned in the device manager, and that is why windows doesn't like them. I have tried the following: 1. Running the software in compatibility mode: 2. BCDedit.exe set testing, signing, etc.
Please view this page. It has more of a driver issue than a hardware, but it could be a hardware issue. I desperatley need help, as if I don't get my brother's computer to have internet, I won't be able to use a new laptop I just ordered.
Netgear installation problems
in Hardware & Devices

Hello. My (steeply technically challenged brother) has an optiplex 745 (slim) running Win7 32 bit. I need to install this Netgear driver on the computer. The hardware is already inside the computer as a PCI chip. It ran fine with XP, but when I installed Win7 for him, it destroyed the driver....
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

 © Designer Media Ltd
All times are GMT -5. The time now is 10:20.
Find Us