New
#11
No worries, post the configuration whenever you can and we will do our best to offer a solution :)
Josh!
No worries, post the configuration whenever you can and we will do our best to offer a solution :)
Josh!
Two routers means you need to turn OFF DHCP on the secondary router. The first router will be handing out IP's through DHCP. Ethernet and WiFi makes no difference, they will all be on the same subnet/network.
It's also important that you use only the LAN port on the secondary router. Plug one of the first routers LAN ports into a LAN port on the secondary router. Do not use the WAN port on the secondary router.
Remember that once the secondary router picks up an IP from the first router, you will then need to access the secondary router through it's new IP which will be in the same subnet as the first router. This new IP should show up on the DHCP list of the first router.
This means that the secondary router will pick up the correct default gateway and IP in the correct subnet from the first router. This will create a common network for all machines connected to either router. After doing this you will have no problems setting up a Homegroup between all machines.
That is all there is to it. :)
the trick is how you connect router to router. From the router#1 (that connected to the modem) connect to
router#2 using a LAN slot and leave the WAN slot of that router empty. You need to disable the DHCP service in
router#2 which will then cause router#1 to make all assignments (thus creating all connections on the same tcp subnet).
Technically, this converts router#2 into a simple switch without the NAT service.
Also, if router#2 is WiFi enabled, it can still provide all WiFi support. If router#1 or the modem have wifi,
I would disable both of them.
This setup allows the creation of a single subnet, but other issues need to be addressed if
one is interested in Print/File Sharing (eg workgroup names must match).
Why would you repeat what I just said, best to read the reply's first maybe. The first router is actually a combo unit modem/router. :)
And there is no reason to disable the wireless on either of those routers. You can set them both up with the same SSID, security password etc. if desired, or create two separate A/P's "on the same subnet" with different SSID's. Depends on the situation. The modem/router combo unit only has one access point.
So it seems to have worked chev65, thanks! I turned DHCP off on the secondary router and then plugged the ethernet cable into an 'ethernet' port instead of the 'internet' port and I'm now able to access Comp 1 and vice versa, as well as it's printer.
How can I remove the original network that is no longer needed? I seem to have two networks now, the new one and the original.
EDIT: It disappeared after disabling and enabling the adapter :)
Last edited by keyboardface; 05 Jul 2013 at 11:50. Reason: Fixed it :)