New
#11
I just had success getting the XP box to see and connect to the Win 7 box by removing the XP machine from the workgroup and connect via IP.
A quick work around I would do is set up FTP servers, that way it's more secure than just windows file sharing. It also works no matter if it's on XP/Vista/Win7... I like to have one machine as a main server to store files (when I have the money... )
Thanks for the advise on FTP however that does not apply to this case if you read the full description this is a fileshare so that an application can be ran on multiple clients hosted from a single point of install.
He says hosting an application via file share, I didn't know he is installing it on one computer to run on multiples. In context you can host an application and still be meaning just to host it so they can install on their own computer. Though He could run a SAMBA share so that the other computers see it as a drive if I'm not mistaken.
Verify that the XP and Vista machines can communicate (XP can access Vista and Vista can access XP). When dealing with networking, never assume anything.
They can, it's just a bitch. I was sharing internet with another computer once... ICS through wireless, and we would have to have him set up the wireless channel and me connect to it for ICS. Yet I'm the one who should be starting the wireless, ugh whatever we bought a router.
This maybe a shot in the dark but it worked for me with my XP boxes.
Follow these steps to check for problems on the machine you cannot access.
1) Open the registry editor on the machine you cannot connect to by clicking on Start, Run
2) Type REGEDIT and press Enter
3) Click on the plus signs (+) next to the following entries
HKEY_LOCAL_MACHINE
SYSTEM
CurrentControlSet
Services
Lanmanserver
Parameters
4) In the right-hand portion of the Registry Editor look for a key called IRPStackSize
5) If the key exists, double-click on it and increase the decimal value to 15 and click OK. Close the Registry
Editor, reboot the computer and try to connect to the network
share. If you are still unable to connect follow the above steps again and increase the decimal number for
IRPStackSize by 5 and try again. Continue to do this until the
stack size is large enough to permit access. Personally, I had to increase the number to 25 before I could connect.
The decimal range for the parameter is between 11 and 50.
6) If the IRPStackSize key DOES NOT exist in the right-hand column of the registry editor, then click on
right-click in the blank area in the right-hand column and choose
New
7) Then Click on D-Word under the Key column
8) In the Name of the new key, type the name IRPStackSize and press Enter. Type the name with the correct
capitalization as shown above.
9) Now double-click on the IRPStackSize key and type 15 in the value data box and place a dot next to Decimal then
click Ok.
10) Close the registry editor and reboot the computer. Try to access the network share again. If the same error
appears follow the steps above to increase the value and
reboot again. Continue this procedure until the problem is resolved. The decimal range for the parameter is between
11 and 50.