KB4534310 Security Monthly Quality Rollup update Windows 7 - Jan. 14

Page 1 of 4 123 ... LastLast

    KB4534310 Security Monthly Quality Rollup update Windows 7 - Jan. 14


    Last Updated: 07 Feb 2020 at 22:49
    January 14, 2020 - KB4534310 (Monthly Rollup)

    Applies to: Windows 7 Service Pack 1, Windows Server 2008 R2 Service Pack 1, Windows Embedded Standard 7 Service Pack 1, Windows Embedded POSReady 7, Windows Thin PC

    IMPORTANT Verify that you have installed the required updates listed in the How to get this update section before installing this update.

    IMPORTANT Customers who have purchased the Extended Security Update (ESU) for on-premises versions of some operating systems must follow specific procedures to continue receiving security updates after extended support ends on January 14, 2020. For more information, see KB4522133.

    IMPORTANT Starting on January 15, 2020, a full-screen notification will appear that describes the risk of continuing to use Windows 7 Service Pack 1 after it reaches end of support on January 14, 2020. The notification will remain on the screen until you interact with it. This notification will only appear on the following editions of Windows 7 Service Pack 1:


    Note The notification will not appear on domain-joined machines or machines in kiosk mode.

    Improvements and fixes

    This security update includes improvements and fixes that were a part of update KB4525251 (released November 19, 2019) and addresses the following issues:

    • Security updates to the Microsoft Scripting Engine, Windows Input and Composition, Windows Storage and Filesystems, and Windows Server.

    For more information about the resolved security vulnerabilities, please refer to the Security Update Guide.

    Known issues in this update

    (Updated 2/7/2020)
    KB4539601 Preview of Monthly Quality Rollup Update Windows 7 - Feb. 7
    KB4539602 Stretched wallpaper displayed as black fix Windows 7 Feb. 7

    KB4534310 Security Monthly Quality Rollup update Windows 7 - Jan. 14-2.jpg

    How to get this update

    Before installing this update

    Prerequisite:

    You must install the updates listed below and restart your device before installing the latest Rollup. Installing these updates improves the reliability of the update process and mitigates potential issues while installing the Rollup and applying Microsoft security fixes.


    After installing the items above, Microsoft strongly recommends that you install the latest SSU (KB4536952). If you are using Windows Update, the latest SSU will be offered to you automatically. To get the standalone package for the latest SSU, search for it in the Microsoft Update Catalog. For general information about SSUs, see Servicing stack updates and Servicing Stack Updates (SSU): Frequently Asked Questions.

    Install this update

    KB4534310 Security Monthly Quality Rollup update Windows 7 - Jan. 14-1.jpg

    File information

    For a list of the files that are provided in this update, download the file information for update 4534310.


    Source: https://support.microsoft.com/en-us/help/4534310


    Direct download links for KB4534310 MSU file from Microsoft Update Catalog:

    Download KB4534310 MSU for Windows 7 32-bit (x86) - 205.2 MB

    Download KB4534310 MSU for Windows 7 64-bit (x64) - 314.0 MB
    Brink's Avatar Posted By: Brink
    14 Jan 2020



  1. Posts : 18
    Windows 7 Ultimate 64 bit
       #1

    It wouldn't install. It got stuck at Searching for updates on this computer
      My Computer


  2. Posts : 76
    Windows 7 Pro 64-bit SP1/Windows 10 Dual Boot
       #2

    One of this week's updates (not sure if it was 4310 or 5102) wrecked my laptop which will continue to run Win7.
    It got to 100% and stayed there for 3 hours so I had to cold boot.

    It rebooted and stayed at 35% for another hour so I did a restore of the partition from my Backup.
    I'm going to try them again one at a time and see what happens.
      My Computer


  3. Posts : 33
    Windows 7 Professional x64
       #3

    This is the last update for Windows 7
      My Computer


  4. Posts : 76
    Windows 7 Pro 64-bit SP1/Windows 10 Dual Boot
       #4

    Updates worked one-at-a-time this time.
      My Computer


  5. Posts : 233
    Windows 7 Home Premium 64 Bit (Service Pack 1)
       #5

    These last updates are not going at all well. The network update wasn't progressing, stuck on downloading at 0%, so I stopped it. Updates says it was successfully installed but can't see how it can be. The quality roll up, the same, won't progress past 0% and am currently trying to install the malicious software removal and the same thing is happening with that. Have never had a problem before.

    In addition to that, there are two additional optional updates, a network card adapter which has also failed.

    What a leaving present!

    LB
      My Computer


  6. Posts : 76
    Windows 7 Pro 64-bit SP1/Windows 10 Dual Boot
       #6

    Is Windows Update creating the Restore points before each update?
      My Computer


  7. Posts : 233
    Windows 7 Home Premium 64 Bit (Service Pack 1)
       #7

    dlwmacgregor said:
    Is Windows Update creating the Restore points before each update?


    I create a RP myself as a safety point before I begin to install updates. But with these latest updates, I don't think it's getting to the point where it is creating a RP. I've abandoned it all for now. My laptop is working perfectly at the moment and I certainly don't want to wreck it with these latest updates. I'll wait for a few days.


    I was installing each update separately and it seems rather coincidental that it should happen with all three.
      My Computer


  8. Posts : 76
    Windows 7 Pro 64-bit SP1/Windows 10 Dual Boot
       #8

    Have you also done a Backup of the laptop? That's what saved me.
      My Computer


  9. Posts : 233
    Windows 7 Home Premium 64 Bit (Service Pack 1)
       #9

    dlwmacgregor said:
    Have you also done a Backup of the laptop? That's what saved me.
    Yes I have system images going back six months or so, so no harm's been done.

    I've just tried again, and all three have now installed OK. The optional updates that came through initially, Broadcom Adapter 802.11n and Intel - Other hardware Management Engine Interface - have both disappeared but there is now a servicing stack update.

    I'll leave that for tomorrow, enough fun and games for today!

    LB
    Last edited by LevelBest; 18 Jan 2020 at 08:50. Reason: update
      My Computer


 
Page 1 of 4 123 ... LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

Designer Media Ltd
All times are GMT -5. The time now is 20:43.
Find Us