Undervolting Ram bsod

Hello, i am using a set of Dominator GT 2000mhz Ram Amazon.com: Corsair CMG6GX3M3A2000C8 6 GB Dominator GT PC3-16000 2000Mhz 240-pin Triple Channel DDR3 Memory Kit: Electronics

Dram Bus Voltage should be 1.65v, mine are set at 1.50v underclocked to 1066mhz on a Gigabyte x-58a-ud3r motherboard, and at the moment my pc gets multiple bsod's attributed to memory corruption. I am wondering is this voltage setting may be responsible for the errors, and if a simple bios Dram bus voltage change would fix it.

A 12 pass run of memtest86 showed 1 error, i asked someone if i should rma, he suggested that with only 1 error it's more likely a bios setting issue than a hardware issue.

Len19 said:

Hello, i am using a set of Dominator GT 2000mhz Ram Amazon.com: Corsair CMG6GX3M3A2000C8 6 GB Dominator GT PC3-16000 2000Mhz 240-pin Triple Channel DDR3 Memory Kit: Electronics

Dram Bus Voltage should be 1.65v, mine are set at 1.50v underclocked to 1066mhz on a Gigabyte x-58a-ud3r motherboard, and at the moment my pc gets multiple bsod's attributed to memory corruption. I am wondering is this voltage setting may be responsible for the errors, and if a simple bios Dram bus voltage change would fix it.

Dunno, depends. Use CPU-Z to look at the SPD profiles. There may be one for 1066 MHz. If so it will tell you the voltage and timings for the profile. Then set those in your BIOS (or use the XMP option if your BIOS supports it to select and set the profile).

I'm curious as to why you are running 2000mhz RAM @ 1066mhz?

Why not run it at it's rated timings and voltages?

Whatever the reason increasing the DRAM volts should certainly help.

smarteyeball said:

I'm curious as to why you are running 2000mhz RAM @ 1066mhz?

Why not run it at it's rated timings and voltages?

Whatever the reason increasing the DRAM volts should certainly help.

Main reason, it came at 1333mhz by mobo default, and i was getting bsod issues, it automatically dropped itself down to 1066mhz after more bsods. 2000mhz ram usually can't get that high most of the time. I'll raise the ram clock speed once i get the ram stable.

Fair enough.

Although a 3x2GB kit rated for 2000mhz should be able to run at spec without issues. It's normally when you run 12GB that it can get a bit iffy.

If you haven't already, set the DRAM volts to 1.65V (or 1.64V if your BIOS won't allow 1.65V) loosen the timings even further to 9-9-9-24 @1066mhz and even bump your QPI/Vtt volts a few steps and re-run memtest. This will rule out BIOS settings as an issue.

If you still get any errosr with sufficient volts and very loose timings, then it's most likely a bad module (or a dimm slot if it's a new board).