New
#161
Fan Setup
It sure is! More details about that to come, for sure! Thanks!
After gluing a few blocks of foam together with a spray adhesive, I trimmed the block down to the appropriate size using a bandsaw.
Unfortunately, it wouldn't fit in order to do the vertical cut...
So I took out the trusty hand saw!
Here's the plan for the fan layout
At first I tried cutting the holes with a good quality knife, but the cuts were not very consistent and it took a long time. I ended up using an old drywall saw, which worked perfectly.
Test fit
Cut some more holes
Awesome!
Let's see how it looks in the right-hand cabinet
LOL - hilarious. It shouldn't fit like that. At least, it didn't during my initial measurements! I'll have to tweak that a bit later!
On to the crazy fans. I decided to go with 3 instead of 4. There just wasn't enough room for foam between each of the fans, and I figured there would be a lot of vibrational noise if they were touching. I could always go to 4 in the future if this proves to be insufficient.
Lookin good
Stay tuned! More stuff tomorrow!