New
#1321
Niklu, nice looking rig. that D14 didn't give the 690 much room did it. On my last rig, my D14 wouldn't let me put my card in the top X16 slot, I had to put it in the second slot. Nice job. Good looking rig.
Niklu, nice looking rig. that D14 didn't give the 690 much room did it. On my last rig, my D14 wouldn't let me put my card in the top X16 slot, I had to put it in the second slot. Nice job. Good looking rig.
I have finally gotten the 4 Noctua fans I wanted into my case. All for about $45 today
Too bad they don't make fans for power supplies so I can replace that one also.
Sooner or later, I am going to replace the 200mm exhaust fan at the top with possibly 4 92mm or 80mm Noctua fans hopefully.
Ok you ready for this....lol
If you do not use your Hotswap bays, Take out the four screws that hold the Power/Sata connectors and remove them (the whole metal piece). Now just move your XSPC pump/res down into the Hotswap bays, Then move dvd/cd drive and Fan controller down two spots each, This leaves your top two 5.25 bays open. Now turn you 360 rad around so that the intake/outtake's are in the 5.25 bays, this should now leave you just enough room to put your 140 rad + one push/pull fan at your rear exhaust (where your rear fan is now) .![]()
Last edited by jeepmann4x4; 28 Jun 2012 at 04:24. Reason: move two spots, not one
Hello Essenbe i have my card in top slot, not much space there,but enough :)
ganjiry Yes i like R.a.t mouse too. i had first r.a.t3 but sidebutton went broken "hard playing" then i bought razer naga and it doesnt fit my hands very well,, so i bought r.a.t 7 and now its good to play battlefield :)
Terronium 12 I see that 690 is what u have to have
A Guy Thank you for welcoming me in seven forums and thanks all for positive feedback![]()