New
#341
Can you give us a pic while it's under load?
I mailed you my result PM IBT
0#68C
1#76C
2#73C
3#73C max load IBT VOLTAGE 1.18 somthing think it's too high ?
No, that is really low for that clock speed. I PM'd you back, and I'm just thinking these newer IB chips are made a lot better.
Tommy, I relly can't tell. CPUz is not reading the voltage right. HW monitor seems to be saying 1.184. If that is right at 4.5, you have a 'golden chip'. Have you tried the fix for CPUz? That's what I go by, but yours is reading speedstep voltage, not the current voltage. All CPU's are different. I usually start with manual voltage and would set it at 1.25 and try that, if I passed 30 minutes of Prime I would drop it to 1.20 and try again, keep dropping it until It wouldn't run it. Then bump it back up .010 and make a full run at prime. If I passed that, convert it to offset and run it again. That's just the way I do it, everyone has their own way. But with manual voltage, what you set is very close to what it will be in prime. That's how you will know exactly what is needed for the chip and board to pass prime. Then convert it to offset and run that way. But, if you are at 1.184, give it a try. It really matters what Vcore goes to during Prime, not what is set in bios. Thus, why I use manual to find my lowest vcore. Offset fluctuates too much.
BTW, to convert use the VID in core temp. Vcore - VID = Offset (+/- .010)
That's what I was getting at Steve, the 1.18x voltage he told me about earlier. That is really low. Tommy, something weird, the 3770k @ 4.5GHz should run IBT quite a bit faster. Here is my 3570k @ 4.5GHz...see if you can spot the difference.
Tommy, did you change anything else in the BIOS after you read that guide? Load Line Calibration, Current Capability, etc?
Kelly, I'm pretty sure the 3570 will get more Gflops than the 3770K. I know I was surprised at that when I went from a 2500K to a 2600K.
the IBT test maybe because my ram speed i went through that guide Steve gave me read it from head to toe tried some of the setting and that is what i got
@ Kelly if you have the same board what were your settings just curious also my ram is 1600mhz if that makes a difference and the ibt ran that fast on stock so i don't know