Official Seven Forums Overclock Leader boards

Nice one Doug! Do you remember what voltage you were running to get that OC?

Well, it looks like my OC'ing days are over for the time being, at least on this board.

I keep getting bluescreens, usually with E1, D1 and A1 errors, which appear to be related to VCore.

I've tried setting the VCore to offset at -0.030 :- VCore at 4.6GHz is 1.232 steady, and VID is 1.2610 with a highest stress value of 1.2710.

I am unable to run IBT because Linpack keeps stopping, and the system then bluescreens.

RAM on XMP is set at 1866MHz and I cannot change it back down to 1600.

At least the temps are decent.

The 4 x 4 GB RAM kit I am running now may have been a mistake, so I may get some new RAM and make it faster while I am at it. GSkill's TridentX F3-2400C10D-16GTX 2400Mhz 16GB (2 x 8 GB) kit is looking real good.

Otherwise, voltages across the board are rock steady.

Going back to stock now.

Well, I have everything back at stock but why is this (note the CPU speed in CPU-Z)?

I think your ram is throwing the line pack error

I know when I oc'ed my ram to 1800mhz from its limit 1600mhz it gave the same error dropped it to the 1600 went through like a champ

have you applied default setting and restarted your oc ?

also I doubt you need XMP mode if your board can support you switching the ram speed yourself

The speed in your screen shot is just idle speed, it will ramp up to full speed when under load Pillian.

Tried IBT again with my RAM at stock speeds and it threw the same error.

kbrady1979 said:

Nice one Doug! Do you remember what voltage you were running to get that OC?

I think it was 1.45. Check this one out

Dude said:

kbrady1979 said:

Nice one Doug! Do you remember what voltage you were running to get that OC?

I think it was 1.45. Check this one out

And you think you need another motherboard?

Dude said:

kbrady1979 said:

Nice one Doug! Do you remember what voltage you were running to get that OC?

I think it was 1.45. Check this one out

You just took the Crown

essenbe said:

Dude said:

kbrady1979 said:

Nice one Doug! Do you remember what voltage you were running to get that OC?

I think it was 1.45. Check this one out

And you think you need another motherboard?

LOL.

Dude said:

kbrady1979 said:

Nice one Doug! Do you remember what voltage you were running to get that OC?

I think it was 1.45. Check this one out

Congratulations Doug, an epic speed mate