Will This Motherboard & Graphics Card Fit My Case?

Case - Apevia X-Sniper 2 (Blue)

Graphics Card - Radeon R9 285

Motherboard - ASUS P8B75-M/CSM LGA 1155 Intel B75 HDMI SATA 6Gb/s USB 3.0 Micro ATX Intel Motherboard

So you think it will fit, and if I need space I can remove the bay you were talking about?

Aprevia X-Sniper: “Fits graphics cards up to 13” in length”.
PowerColor Radeon R9 285: “4.41” x 10.5” x 1.5”.
Macro ATX is standard (11” x 12”).

That extra 0.1” (if it isn’t a typo) shouldn’t matter, unless that case has an odd motherboard tray design. But I wouldn’t expect it to. I also believe all Micro ATX boards are standard (same dimensions).

However, you’re going to spend a small fortune adding the fans that this case doesn’t include (only one 120mm rear exhaust is preinstalled). You really would save more money in the long run choosing one that has them included (I'd aim for no less than 5-6 preinstalled fans; 3 exhaust, 2-3 instakes). I thought to get a $50 case and do that as well, thinking I'd save a grip of money, but it was going to run me over $100 (and I wasn’t even looking at the fancy fans either). So I just went with a $100-ish case and didn’t have to mess with the fans at all (this also bumped me into some handy cable management options on the motherboard tray, dust filters on every intake, built-in fan controller and so forth). I spent the same amount of money I would have on the fans by themselves, but got a heck of a lot more for it. Just saying you may wish to consider that.

But if you’re set on that case, I hope you’re also planning for a closed loop water cooling solution... at 7.75” wide, your HSF options otherwise would be pretty limited for air cooling off of stock. The better air coolers demand on average at least 9” in case width (and some of that width space gets eaten up by the motherboard standoffs too, so that would be closer to about 7.25” in reality). You will also, most likely, not be able to utilize the side fan mounts with an aftermarket air HSF (I also sacrificed my 200mm side fan for my HSF; they're nice but not strictly necessary. Air will be pulled in through the side vents without a fan pushing it in). Just FYI.

Also, I wouldn’t put anything in the middle HDD bay for the best air flow. Keep your drives down on the bottom four bays, if at all possible. It would be best if you could outright remove that section but I don’t think that’s possible on the case you’re currently looking at – I do not see that mentioned anywhere in the specifications or features, and it looks to be one solid metal cage to me as well (most of the removable cages are plastic, with side tabs for removal).

Hi,

I actually have decided to go with another motherboard (11" x 11"), but I might need some help on the fans. I read what you said, but I am still a little confused (I'm new at this).

Please see this thread to help if you would :)

What Fan System Should I Use?