I have a similar situation, originally installed (DDR2 here, runs on steam lol) 2x1gb Hyperx then later bought another 2x1gb Hyperx, same model different part. Even using ASUS TURBO motherboard (made for clocking) I have been unable to get the XMP timings to work properly. I do not have options to tweak each bank of ram individuay, but by nudging up the latency a tad I finally got the xmp frequency I was looking for.
Hey guys
So i just got to install the new 8 gigs :) (i know, took me sometime since i was out of town) installed them,all looks good,did a reset for the BIOS XMP profile then reapplied profile #1(2400mhz 165v),here is what it looks from the RM :
CPU-Z:
PASSMARK PerformanceTest:
Memory Mark 3191
Database Operations 109.2
Read Cached 30308
Read Uncached 19022
Write 12407
Available RAM 14350
Latency 20.4
Threaded 32458
...all good ?
Do you guys recommend doing some sort of stress test ?
Beautiful :)
You could run winsat mem in a command prompt and post the score if you`d like, run it 3 or 4 times then post the snip showing all 4 scores.
Not sure why you got those last 2 scores, your ram should run consistently in the 31xxx range, run it like 10 times in a row.
Quote
