Macrium Reflect (Free 5.0.4118): need help on "recover partition"

Page 3 of 4 FirstFirst 1234 LastLast

  1. Posts : 19,383
    Windows 10 Pro x64 ; Xubuntu x64
       #21

    Frank, how are you writing this ISO to the USB drive?
      My Computer


  2. Posts : 34
    Windows 7 Professional 64 bit
       #22

    I'm using YUMI ...
      My Computer


  3. Posts : 19,383
    Windows 10 Pro x64 ; Xubuntu x64
       #23

    Ok, there are no spaces in the ISO name, which is normally where the issue is with YUMI. Are you using the unlisted ISO option? I'm stumped.....how far into the boot process do you get?
      My Computer


  4. Posts : 34
    Windows 7 Professional 64 bit
       #24

    Yes, I used the "unlisted ISO" ... last option in the list. As far as visible during booting, it loads the iso probably until end, since it takes that about 2 minutes as it did with the other iso (which didn't bring any target disks unfortunately) ... and then just reboots ...
      My Computer


  5. Posts : 19,383
    Windows 10 Pro x64 ; Xubuntu x64
       #25

    Frank, does the Macrium Recovery actually load?
      My Computer


  6. Posts : 34
    Windows 7 Professional 64 bit
       #26

    It does not with the WinPE isos but it does with the Linux iso though. Only there no target disks are provided yet.
      My Computer


  7. Posts : 19,383
    Windows 10 Pro x64 ; Xubuntu x64
       #27

    Frank, could you take a photo of what you are seeing when you use the Linux option, and post it here for us please?
      My Computer


  8. Posts : 34
    Windows 7 Professional 64 bit
       #28

    sure







      My Computer


  9. Posts : 19,383
    Windows 10 Pro x64 ; Xubuntu x64
       #29

    Frank, Macrium isn't even booting! It looks like you are using the boot from the 'Run from RAM' option. Please use the next option up, as shown below.

    Macrium Reflect (Free 5.0.4118): need help on "recover partition"-capture.png
      My Computer


  10. Posts : 34
    Windows 7 Professional 64 bit
       #30

    ok, I checked it with a new YUMI sesion with "Try an unlisted ISO", but after booting with YUMI and selecting that iso, it did not load the iso and returned immediately to re-boot.
    I then created a new iso and yumi-write-to-USB (screenshot sequence), but that also didn't load and went to re-boot immediately.
    When I followed MACRIUM REFLECT - Create Bootable Rescue USB Drive at the first try, it did load the iso and did show my disk to select the drive-image, but then did not show any target disks.













      My Computer


 
Page 3 of 4 FirstFirst 1234 LastLast

  Related Discussions
Our Sites
Site Links
About Us
Windows 7 Forums is an independent web site and has not been authorized, sponsored, or otherwise approved by Microsoft Corporation. "Windows 7" and related materials are trademarks of Microsoft Corp.

© Designer Media Ltd
All times are GMT -5. The time now is 00:06.
Find Us